VISIONPRO® IAQ TOTAL HOME COMFORT SYSTEM
68-0287—1 4
Fig. 5. C7189U1005 Remote Indoor Sensor dimensions in in. (mm).
INSTALLATIONWhen Installing this Product...1. Read these instructions carefully. Failure to follow the
instructions can damage the product or cause a hazard-
ous condition.
2. Check the ratings given in the instructions to make sure
the product is suitable for your application.
3. Installer must be a trained, experienced service
technician.
4. After completing installation, use these instructions to
verify the product operation.
Selecting LocationInstall the thermostat about 5 ft. (1.5m) above the floor in an area
with good air circulation at average temperature. See Fig. 6.
Fig. 6. Selecting thermostat location.
Do not install the thermostat where it can be affected by:
— Drafts or dead spots behind doors and in corners.
— Hot or cold air from ducts.
— Radiant heat from sun or appliances.
— Concealed pipes and chimneys.
— Unheated (uncooled) areas such as an outside wall behind
the thermostat.
Installing WallplateCAUTION
Electrical Hazard.
Can cause electrical shock or equipment damage.
Disconnect power before wiring.
The thermostat can be mounted horizontally on the wall or on a
4 in. x 2 in. (101.6 mm x 50.8 mm) wiring box.
1. Position and level the wallplate (for appearance only).
2. Use a pencil to mark the mounting holes.
3. Remove the wallplate from the wall and, if drywall, drill
two 3/16-in. holes in the wall, as marked. For firmer
material such as plaster, drill two 7/32-in. holes. Gently
tap anchors (provided) into the drilled holes until flush
with the wall.
M23522
2-9/32
(58)
1-1/2 (38)
2-9/32
(58)
1-1/2 (38)
45/64
(18)
FRONT VIEW SIDE VIEW FRONT VIEW (COVER OFF)
5 FEET
[1.5 METERS]
YES NO
NO
NO
M19925