THX9321/9421 P restige® IAQ and RF EIM
369-2490 —03
MCR29241
MCR32386
Install thermostat
1
• THX9421:MountthethermostatandwiretoCandRterminals ofthe
EquipmentInterfaceModule(EIM),ortoaseparate24volt transformer(not
provided).
• THX9321:InstallandwireasaboveifusingEIM.Ifnot, seepages13-15.
Seepages10-17fordetailedwiringguidelines
MCR32387
MCR32389
R
C
Y
Y2
G
L
W
O/B
W2
AUX1
W3
AUX2
Strip 1/4” insulation, then insert wires as shown.
Install Equipment Interface Module (if used )
2
[If no EIM is used, skip to Section 3.]
Usescrews&anchorsasappropriateforthemountingsurface.Mountthe EIM
neartheHVACequipment,orontheequipmentitself.
MCR32388
NOTE: If you install more than one thermostat and
EIM, the EIMs must be at least 2 feet apart.
If installing a discharge/return air sensor, it must
be located between the IAQ equipment and the
heating/cooling equipment. The sensors must be
in air that is mixed well (away from a-coil/heat
exchanger). See page 7.
When used with the EIM, the relays in the thermostat do not function.
69-2490_B.indd 3 7/13/2011 1:41:48 PM