away from direct sunlight, rain or snow. The best suggested location for the remote sensor for outdoors is under the eave on the north side of the building.
NOTE: When the temperature falls below freezing, the batteries in the outdoor remote sensor may have reduced voltage supply and a shorter effective range. We recommend using lithium batteries at temperatures of 32°F (0°C) and below.
BATTERY INSTALLATION
REMOTE SENSOR
NOTE: Install the batteries; select the temperature in °C or °F before mounting the remote sensor.
•Remove the screws from the battery compartment with a small Phillips screwdriver.
•Install 2 “AA” size alkaline batteries (not included) matching the polarities shown in the battery compartment.
•Replace the battery compartment door and secure the screws.
•Secure the remote sensor in the desired location.
MAIN UNIT
•Remove the battery compartment door.
•Install 2 batteries
•Replace the battery compartment door.
LOW BATTERY WARNING
A 
] will appear next to the indoor or remote data reading line of the main unit warning that the corresponding batteries need replacement.
9
GETTING STARTED
WEATHER DISPLAY
After batteries are installed; remote sensor will transmit temperature data at 45 second intervals. The main unit may take up to two minutes to receive the initial readings. Upon successful reception, remote temperature will appear on the top line of the main unit’s display .The main unit will automatically update readings at
After communication between the main unit and remote sensor has been established, secure the remote sensor in the desired location.
If no signal is received from the remote sensor within two minutes, dashes [- -
PLACEMENT OF THE UNITS
The main unit can be placed on any flat surface indoors. The remote sensor can be placed indoors or outdoors, on a flat surface or mounted on the wall.
REMOTE AND INDOOR TEMPERATURE
The remote temperature information line is located on the top line of the main unit’s display with abbreviation OUT next to it.
The wave icon is located above the OUT indicates the reception status from the remote sensor.
There are three following types of the reception status may be displayed:
The unit is in a searching mode.
Temperature reading is |
|
securely registered. |
|
No signals detected. | - - - |
9 | 10 |
