5.Log into your remote account via a PC browser. Click on the Account Settings tab on the interface and then select the Discovery
NOTE: If your XG1000 Controller is not registered to your account you must register it prior to proceeding.
DEVICE DISCOVERY PAGE
On the Discovery page, click on the ‘START DISCOVERY’ button to start the Bridge registration process. When the page heading
indicates that discovery is in process, press the ‘DISCOVERY’ DISCOVERY
COMPLETING THE INSTALLATION ///
1.Access your remote account via a PC browser and log in using your account UserID and Password.
2.Click on the Device Overview tab to access the Device List for the system.
Once you are at the Device List, click on the Settings icon 
for the HoneywellAlarmPanel to the right of the Device List.
button on the lower left corner of the Honeywell Bridge device as shown.
DEVICE DISCOVERY IN PROGRESS
BUTTON
DEVICE OVERVIEW PAGE
3.Send a test command through the Virtual Keypad to disarm the system and the status of the panel will appear.
When the Discovery process has finished for the Honeywell Bridge, it will appear on the list
of your devices on the Discovery page, and the LED on the Honeywell Bridge should turn GREEN. At this point you may press the ‘STOP DISCOVERY’ button to stop the Discovery process.
HONEYWELL ALARM PANEL DISCOVERED
After the system has registered the Honeywell Bridge device, go to the Device Overview page and verify that the Honeywell Bridge device was properly discovered.
3 | 4 |
