N |
|
|
Pull support toward bottom of han- dle slightly to make sure support is locked in place.
Make sure hole in handle (N) is visi- ble through hole in support.
With cloth bag to the front, place assembled handle onto handle base of cleaner body.
Rock handle side to side while pushing down firmly. Extra push- ing effort may be required.
Push bolt into hole on lower front of handle.
If bolt will not go through hole easily, handle is not pushed com- pletely down.
O |
Place nut (O) in recessed area at back of handle. Hold nut in place while tightening bolt securely with a screw driver.
Note: Only one nut is needed on this model. The extra nut is not required but has been provided for your convenience.
Reposition dirt cup into support at bottom of cloth bag and snap latch- es into position.
P
Q
Pull switch lock (P) above
Dispose of lock.
Note: If lock has come off during assembly, make sure switch is in the OFF position (down) before plugging cord in to electrical out- let.
2. How to use
Cleaner description
2
3
4
5
| 6 |
11 | 8 |
7 | |
| 10 |
9
The assembled cleaner will look like the drawing.
1.Handle
2.ON/OFF switch
3.Cord hooks: wrap cord around hooks for storage.
4.Bag cap
5.Cloth bag
6.Dirt cup
7.Handle release lever: step on lever to lower handle to operating or low position.
8.Cleaner body
9.Furniture guard: helps prevent cleaner from marking furniture.
10.Hood
11.Extra belt storage: open door to store extra belt.
Operate cleaner only at voltage speci- fied on data plate on bottom of cleaner.
WARNING: electrical shock could occur if used outdoors or on wet surfaces.
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a quali- fied electrician to install the proper outlet. Do not change the plug in any way.
ON-OFF switch
To turn cleaner ON, push switch up. To turn cleaner OFF, push switch down.
4
