Hoover DDY 088T, DDY 088TX AUTOMATIC FAULT SIGNALS, "DELAY START" button, Alarm mute for the PROGRAMME END, "00, "b1, "b0, CAUSE, "START, "RESET, second, FAULTS, "ON/OFF, "ON/OFF

"DELAY START" button

Dishwasher start time can be set with this button, delaying start from 1 to 23 hours.

Proceed as follows to set a delayed start:

■Press the "DELAY START" button ("00" will appear on the display).

■Press the button again to increase the delay in hours (each time the button is pressed the delay is increased by 1 hour to a maximum of 23).

■To start the countdown, press the "START" button.

The display will show the time remaining to the begin of the programme.

At the end of the countdown, the programme will automatically start and the length of the selected cycle will be shown in the display.

Proceed as follows to cancel a delayed start:

■Hold the "RESET" button down for at least 5 seconds.

■The delayed start and the selected programme will be cancelled.

■At this point, a new programme and option buttons must be set to start a new programme as indicated in the

"PROGRAMME SETTINGS" section.

Alarm mute for the PROGRAMME END

The alarm for the programme end may be muted as follows:

IMPORTANT

The dishwasher must be ALWAYS off before start this procedure.

1.Hold down the "PROGRAMME SELECTION" button and at the same time switch on the dishwasher by pressing the "ON/OFF" button (a brief audible signal will sound).

2.Keep the "PROGRAMME SELECTION" button pressed for at least 15 seconds (during this time 2 audible signals will sound).

3.Release the button when the second audible signal sounds ("b1" will appear on the display to indicate that the alarm is on).

4.Press the same button again ("b0" will appear on the display to indicate that the alarm is off).

5.Turn off the dishwasher by pressing the "ON/OFF" button to confirm the new setting.

To turn the alarm on again, follow the same procedure.

IMPORTANT

This dishwasher is equipped with an anti-overflow safety device which will automatically discharge any excess water should a problem occur.

WARNING!

To ensure the correct operation of the anti-overflow safety device, we recommend that the dishwasher is not moved or tilted during operation. If however it is necessary to tilt or move the dishwasher, please ensure that the washing cycle is complete and that there is no remaining water inside the dishwasher.

The dishwasher is able to signal a series of faults in the display.

AUTOMATIC FAULT SIGNALS

FAULTS	CAUSE	SOLUTION

E2 appears on the display and	No water (inlet hose closed).	Turn off the dishwasher, open the
the alarm sounds.		inlet hose and reset the cycle.

E3 appears on the display and	The machine cannot drain water.	Check if the drain tube is bent or if
the alarm sounds.		the siphon or filters are clogged.
		If the problem persists, contact
		Customer Service.

E4 appears on the display and	Water leak	Check if the drain tube is bent or if
the alarm sounds.		the siphon or filters are clogged.
		If the problem persists, contact
		Customer Service.

E5,E6,E7,Ef or EL appears	Electronic control fault.	Contact Customer Service.
on the display and the alarm
sounds.

E8 or Ei appear on the display	The water heating element is not	Clean the filter plate.
and the alarm sounds.	working correctly or the filter plate is	If the problem persists, contact
	clogged.	Customer Service.