PROGRAMME SELECTION AND SPECIAL FUNCTIONS
(Use in conjunction with programme guide)
IMPORTANT
The dishwasher has a very practical function:
-the memory function which saves the last programme used, so that if you regularly use the same washing cycle, you do not have to
"ACTION PRO" button
This button allows you to modify the wash intensity, according to how dirty your dishes are, by modifying the wash time and temperature.
Press the button to increase the intensity of wash cycle ( 
indicator light) or to reduce the intensity of wash, this also allows you to decrease the wash length time ( 
indicator light).
The combination of the button with the 4 main wash programmes enables to have 8 additional wash cycles (achieving a total of 12 programmes of washing).
IMPORTANT
When the dishwasher is switched on, the setting last used will be indicated.
Programme settings
■Open the door and place the dirty dishes inside the appliance.
■Press the "ON/OFF" button 
. The display will show the last programme used.
■To set another programme, press the "PROGRAMME SELECTION" button.
■If you wish, press the "ACTION PRO" button.
■If you wish to select an option, press the corresponding button (the indicator light will turn on).
The option buttons can be selected or deselected WHITIN one minute of the programme commencing.
■Press the "START" button.
The length of the program will be shown on the display alternating hours with minutes [I.e: 1 h (1 hour) / 25 (25 minutes)].
■When the door is shut, after an audible signal has sounded, the programme will start automatically. The display will show the time remaining to the end of the cycle.
WITHIN one minute of the programme commencing, another programme can be selected, simply by pressing the "PROGRAMME SELECTION" button (it is also possible to change the "ACTION PRO" button setting ).
“AUTOMATIC” programmes
The dishwasher is equipped with a dirt sensor, able to analyse water murkiness during all "AUTOMATIC" programme phases (see programme list); thanks to this sensor the washing cycle parameters are automatically adapted to the real quantity of dirt on dishes. Thus excellent washing results are guaranteed while optimising water and energy consumption.
"IMPULSE" programmes
The “IMPULSE” programmes use an impluse washing technology, which reduces consumption, noise and increases performances.
IMPORTANT
The “intermittent” working of the washing pump MUST NOT BE considered a malfunction, it is a characteristic of the impulse washing so must be considered a normal function of the programme.
Programme interruption
Opening the door when a programme is running is not recommended especially during the main wash and final hot rinse phases. However, if the door is opened while a programme is running (for example, to add dishes) the machine stops automatically and the display will flash the remaining time before the end of the cycle. Close the door, without pressing any buttons. The cycle will start from where it left off.
IMPORTANT
A running program can be interrupted without opening the door by pressing the "ON/OFF" button. In this case, simply press the "ON/OFF" button again to restart the cycle from where it left off.
WARNING!
If you open the door during the drying cycle, an audible audio signal advises you that the drying cycle has not yet finished.
Changing a running programme
Proceed as follows to change or cancel a running program:
■Hold the "RESET" button down for at least 5 seconds.
■The running programme will be cancelled.
■At this point a new programme can be set.
WARNING!
Before starting a new programme, you should check that there is still detergent in the dispenser.
If necessary, top up the dispenser.
Programme operations
Whilst a programme is running, the display shows the time remaining to the end of the cycle, which is automatically updated.
If there is any break in the power supply while the dishwasher is operating, a special memory stores the selected programme and, when the power is restored, it continues where it left off.
Programme end
A 5 second alarm will sound (if not muted) 3 times at 30 second intervals to signal that the programme has ended.
The display and all the indicator lights will switch off.
Dishes can now be removed and the dishwasher turned off by pressing the "ON/OFF" button or dishes can be loaded for new cycle.
Option buttons
"SUPER ECO" button
This button provides an energy and time saving of 25% on average (according to the select cycle) reducing the wash water temperature and the drying time during the final rinse.
This programme is recommended for light soil washes, and for slightly wet dishes that are not fully dry, & improved drying results. We advise you to leave the door of the Dishwasher
"EXTRA DRY" button
This option allows you to achieve the highest efficiency in drying, increasing the wash water temperature during the last phase of washing cycle.
IMPORTANT
The options "EXTRA DRY" and "SUPER ECO" are incompatible and therefore cannot be activated in the same washing cycle.
22 | 23 |