Hoover DYC 9913AX manual Drain Hose KIT Fitting Instructions, Drain Hose Fitting Instructions

DRAIN HOSE KIT: FITTING INSTRUCTIONS

Do not install the product in a room where there is a risk of frost occurring. At temperature around freezing point the product may not be able to operate properly: there is a risk of damage if the water is allowed to freeze in the hydraulic circuit (valves, hoses, pumps).

For a better product performance the ambient room temperature must be between +2°C and +35°C.

4.Attach the black hose from the kit, (using the connector

a n d p i p e c l i p s supplied), to the hose removed from the bridge connection.

DRAIN HOSE : FITTING INSTRUCTIONS

To avoid emptying the water container after each drying cycle, the water can be discharged directly to a waste water drain pipe (the same drainage system as household sinks). Water Bye-Laws prohibit connection to a surface water drain. The waste water drain pipe should be located adjacent to the tumble dryer.

The kit consists of:1 hose and 1 tap.

WARNING! Switch off and remove the tumble dryer plug from the electricity supply before carrying out any work.

5.Once the machine is in place, check the bottom to ensure that the new hose does not kink when pushing the tumble dryer into position.

6.Connect the new drain hose to the waste Water pipe.

7.Connect to the m a i n s e l e c t r i c i t y supply.

Fit the Hose as Follows:

1.Flip the machine slowly to the right side.

2.The waste water pipe is situated at the right-hand side of the machine (see the picture). A grey hose connects to the bridge at the left hand side of the machine. Using pliers, remove the pipe retaining clip from the bridge.

3.Pull the hose off the bridge connection.

Caution: If the product is in different side, wait at least 4 hours before switching on so that the oil can flow back into t h e c o m p r e s s o r . Failure to do this could result in damage to the compressor.

EN 6