Condenser
7
Support the container with both hands.
When full, the water container will
weigh about 4kg (fig. 7).
3. Open the lid located on the top of the
container and empty the water (fig. 8).
4. Refit the lid and slide the water
container back into position. PUSH
FIRMLY INTO PLACE.
5. Refit the kickplate by engaging the
hinges at the top and ‘snapping’ the
lower clips into place.
CondenserIMPORTANT:Always switch off and
remove the plug from the electricity
supply before cleaning the condenser.
To maintain the efficiency of the dryer
regularly check that the condenser is
clean.
To remove the condenser:
1. Remove the kickplate (fig. 5).
2. Turn the two locking levers anti-
clockwise (fig. 9).
3. Pull out the condenser unit (fig. 10).
4. Gently remove any dust or fluff with a
cloth, then wash the unit by holding it
under a running tap (fig. 11) turning it
so that water flows between the plates,
to remove any dust or fluff.
5. Refit the condenser ensuring it is in the
correct way (as indicated by the arrow)
and pushed firmly into place. Lock the
two levers by turning them clockwise.
6. Refit the kickplate.
79
10
11
8
40000133.qxd 11-06-03 17:50 Page 7