If faucet has not threads: attach the faucet adapter to faucet, then tighten every screw of the adapter. To prevent leaking your should tighten the adapter.
Connector of ModelⅠ
1
2
3
Pull Unicouple and its hoses completely out from storage compartment located at rear of dishwasher and attach it to the faucet adapter.
Attach the Unicouple connector to the faucet adapter by depressing the collar at the top of the connector. When Unicouple is all the way up onto the adapter, release the collar. It will then snap Into position to lock the Unicouple in place. The Unicouple' s small hose carries water from the faucet to the dishwasher. Its large hose carries drain water to the sink. Be sure Unicouple is pointing toward the sink bowl drain opening and the sink drain is open for water that will drain from your dishwasher. If your dishwasher drains into a disposer, operate the disposer until it is completely empty before starting the dishwasher.
Turn water fully on before starting the dishwasher.
A hose that attaches to a sink spray can burst if it is installed on the same water line as the dishwasher. If your sink has one, it is recommended thet the hose be disconnected and the hole plugged.
1
2
3
Turn off the water.
Release the water pressure by depressing the pressure release button. This relieves water pressure and protects you, and the room, from severe splashing.
Release Unicouple from faucet by depressing the collar at the top of the Unicouple connector.
1
2
Remove the power cord plug from the wall receptacle. Disconnect Unicouple from faucet adapter.
| Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is | |
| fastened tightly in place. | |
| If the water pipes are new or have not been used for an extended period of time, let the water | |
| run to make sure t hat the water is clear and free of impurities. If this precaution is not taken, | |
| there is a risk that the water inlet can get blocked and damage the appliance. | |
| The water supply to the appliance can also be connected to the house hot water line | |
| (centralized system, heating system),as long as it does not exceed a temperature of 60 C. | |
Con nector of ModelⅡ | In this case, the wash cycle time will be shortened by about 15 minutes and the wash | |
efficiency slightly reduced. | ||
| ||
| The connection must be made to the hot water line following the same procedures as those | |
| for the connection to the cold water line. |
10
