SAFETY INSTRUCTIONS

There are certain basic safety rules which are valid for any domestic appliance.

Installation

Make sure that the plug fitted to the machine is compatible with the power supply socket. If it is not, get a suitably qualified person to fit the correct type, and to make sure that the cables to the mains socket are able to cope with the power rating of the appliance.

Ensure that the dishwasher does not crush power cables.

In general it is not advisable to use adaptors, multiple plugs and/or extension cables.

Should it be necessary to replace the supply cord, call the After Sales Service Centre.

Safety

Never touch the appliance when your hands or feet are wet or damp.

Do not use when your feet are bare.

Do not remove the plug from the mains supply socket by pulling the mains cable or the machine itself.

Do not leave the appliance exposed to the elements (rain, sun etc).

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

Water left in the machine or on the dishes at the end of the wash programme should not be swallowed.

The door should not be left in the open position since this could present a potential hazard ( es. tripping ).

Leaning or sitting on the open door of the dishwasher could cause it to tip over.

WARNING !

Knives and other utensils with sharp points must be loaded in the basket with their points down or placed in a horizontal position.

Daily use

This appliance is be designed for domestic use only.

The dishwasher is designed for normal kitchen utensils.

Objects that have been contamined by petrol, paint, traces of steel or iron, corrosive chemicals, acids or alkalis must not be washed in the dishwasher.

If there is a water softening device installed in the home there is no need to add salt to the water softener fitted in the dishwasher.

Cutlery is washed best if it is placed in the basket with the handles downwards.

If the appliance breaks down or stops working properly, switch it off, turn off the water supply and do not tamper with it. Repair work should only be carried out by an approved service agent and only genuine spare parts should be fitted. Any failure to follow the above advice may have serious consequences for the safety of the appliance.

Disposal

The dishwasher has been made from materials which can be recycled so that it can be disposed of in an environmentally friendly way.

If you wish to dispose of an old dishwasher be careful to remove the door to eliminate the risk of children becoming trapped inside it.

INSTALLATION

(Technical notes)
IMPORTANT

When the appliance is located on a carpet floor, attention must be paid to ensure that there is no obstruction to the bottom vents.

Make sure that the plug on the appliance remains accessible after installation.
Electrical connection

Plug your dishwasher into the power socket.

If the plug we supply does not fit :

CUT IT OFF AND DESTROY IT!

You can't use it on other appliances, and the exposed wires could be dangerous if anyone plugged it in.

Fit a suitable plug, as follows:

Connect
to the terminal in the plug

 

 

 

 

 

Marked with the letter E,

 

 

OR marked with the Earth

 

Green and

symbol,

 

yellow wire

OR coloured green,

 

 

OR coloured green and

 

 

yellow.

 

Blue wire

Marked N,

 

OR coloured black.

 

 

 

Brown wire

Marked L,

 

OR coloured red.

 

WARNING!
THIS APPLIANCE MUST BE EARTHED.
Fuses and plugs

This appliance should be used only on a socket with a minimum rating of 13 Amp.

Our ready-fitted plug is already equipped with a 13 amp fuse which is BS 1362 ASTA approved.

Any replacement should be exactly the same.

If the fuse cover is lost, do not use the plug until it is replaced.

A correct replacement fuse cover (obtainable from your dealer or Electricity board) must be the same colour as shown or named on the insert on the base of the plug.

Manufacturer declines all responsibility for any damage due to non-earthing of the machine.

Appliance complies with European Directives 73/23/EEC and 89/336/EEC, replaced by 2006/95/EC and 2004/108/EC, and subsequent amendments.

4

5