PROGRAMME SELECTION AND SPECIAL FUNCTIONS

(Use in conjunction with programme guide)IMPORTANTThe dishwasher has two very practical functions:

-the "recommended" programme (which is ideal for full load daily use) for quick and accurate selection;

-the "Auto’ Memory", function saves any programme used at least 3 times consecutively, so that if you regularly use the same washing cycle you do not have to continually set the programme thereby saving time and effort.

Programme settings

■ Open the door and place the dirty dishes

■When the required programme is shown in the display, press the "START" button. The length of the program will be shown on the display alternating hours with minutes [I.e.: 1 h (1 hour) / 25 (25 minutes)].

If the previously described operations were performed with the door open, the programme will not start until the door is closed.

Programme interruption

Opening the door when a programme is running is not recommended especially during the main wash and final hot rinse phases. However, if the door is opened while a programme is running (for example, to add dishes) the machine stops automatically and the display will flash the remaining time before the end of the cycle. Close the door, without pressing any buttons. The cycle will start from where it left off.

Changing a running programme

Proceed as follows to change or cancel a running programme:

■Hold the "START" button down for at least 5 seconds (the running programme will be cancelled).

■At this point a new programme can be set.

WARNING!

Before starting a new programme, you should check that there is still detergent in the dispenser.

If necessary, top up the dispenser.

If there is any break in the power supply while the dishwasher is operating, a special memory stores the selected programme and, when the power is restored, it continues where it left off.

Option buttons

IMPORTANT

All options MUST be turned on or off, BEFORE pressing “START” button.
“5 IN 1” button

This option optimises the use of “3 in 1”/ “4 in 1”/“5 in 1” combined detergents. By pressing this button, the selected washing programme is modified to get the best performance from combined detergents; furthermore, the salt and rinse aid shortage lights are de-activated.

WARNING!

Once selected, this option keeps being on (light on) also for next washing cycles and it can be de-activate (light off) only by pressing the button once again.

inside the appliance.

 

■ Press the "ON/OFF" button

.

■ After pressing the "ON/OFF" button, the

programme which is factory

set at

"recommended” or the "Auto’ Memory"

programme will appear on the display.

IMPORTANT

A running program can be interrupted without opening the door by pausing the dishwasher.

To pause, hold the "START" button down for at least 3 seconds and release when the running program starts blinking on the display.

Programme operations

When a programme is running, the time until the end of the cycle will be displayed and the 4 “PROGRAMME STATUS” indicator lights ("WASH", "RINSE", "DRY", "END") will light singularly and in sequence to indicate the current phase.

IMPORTANT

When this option is selected, the "RAPID" cycle is 10 minutes longer.

■ To

select an

option, press

the

corresponding button (the indicator light

will turn on).

 

 

Option buttons must be pressed
BEFORE starting the programme for
them to be accepted.

 

■ To

set another

programme, press

the

"PROGRAMME SELECTION" button
("PROGR.").

 

 

Simply press the "START" button again to restart the cycle from where it left off.

WARNING!

If you open the door during the drying cycle, an audible audio signal advises you that the drying cycle has not yet finished.

Programme end

A 5 second alarm will sound (if not muted) 3 times at 30 second intervals to signal that the programme has ended. The programme end indicator light will light up and the display will go blank.

Dishes can now be removed and the dishwasher turned off by pressing the "ON/OFF" button or dishes can be loaded for a new cycle.

"BOOST" button

The "BOOST" button provides over 20% time and energy savings by reducing the final water heating and drying times during the last rinse cycle.

This option is recommended for light soil washes, and for when the dishes are not required perfectly dry straight away.

If you want to get better drying, we advise to leave the dishwasher door slightly ajar at the end of the cycle, to allow for a natural circulation of air inside the dishwasher.

22

23