Clean brush roll.
Replace Window, reposition screws, and tighten securely.
When to replace
Replace the brush roll when the brushes do no touch the edge of a card as it is moved across the opening on the bottom of the nozzle.
A new brush roll can be installed by your local Authorized Hoover Dealer (Depot) or Hoover Factory Service Center.
Belt
The
Lubrication
Lubrication is not necessary since the motor and brush roll bearings are perma- nently lubricated.
.4. If you have a problem
If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the check list below.
Problem: Cleaner won’t run
Possible cause
Possible solution
•Not firmly plugged in.
•Plug unit in firmly.
•No voltage in wall plug.
•Check fuse or breaker.
•Blown fuse/tripped breaker.
•Replace fuse/reset breaker.
Problem: Cleaner won’t pick up
Possible cause
Possible solution
•Dirt cup full.
•Empty dirt cup.
•Filter clogged.
•Empty dirt cup and clean filter.
•Nozzle clogged.
•Remove debris from brush roll and surrounding area
•Brush roll brushes worn
•Replace brush roll
•Broken belt
•Replace belt
Service
To obtain approved HOOVER service and genuine HOOVER parts, locate the near- est Hoover Factory Service Center or
Authorized Hoover Warranty Service Dealer (Depot) by:
•checking the Yellow Pages under “Vacuum Cleaners - Household” OR -
•checking the list of Factory Service Centers provided with this cleaner OR -
•calling
•checking the Service section of The Hoover Company
Please do not send your cleaner to The Hoover Company in North Canton for ser- vice, this will only result in delay.
If further assistance is needed, contact The Hoover Company Consumer Response Center, North Canton, Ohio 44720 Phone:
In Canada, contact Hoover Canada, Burlington, Ontario L7R 4A8, Phone:
Always identify your cleaner by the com- plete model number when requesting information or ordering parts. (The model number appears in the middle of the back of the cleaner body.)
7
