Hoover Lightweight Commercial Cleaner warranty Attach cloth outer bag, Attach handle

STEP 4 Attach cloth outer bag

7

C

B A

7Note location of tapered rails

(A) on back of outer bag base

(B)and on front of lower handle (C).

8
B	D
	C

8Slide rails on outer bag (B) onto rails on lower handle (C) until

outer bag base snaps past the lock tab (D).

9

B

E

D

9The hole (E) in the handle is visible through the U-shaped

extension on the outer bag base (B) when the outer bag base is in posi- tion past the lock tab (D).

Be sure that power cord is pulled tight and pressed into each of the three notches (Fig. 6) before com- pleting the following steps.

10

H

F

G

I

STEP 5 Attach handle
11	12
	K	NUT
J

10Note round opening (F) and hooks (G) on back of outer

bag (H).

Place opening over dirt tube (I). Unzip outer bag and place hand inside. Press down firmly to snap hooks into handle.

With outer bag to the front, place assembled handle onto handle base

(J) of cleaner body.

Rock handle side to side while pushing down firmly. Extra push- ing effort may be required.

12Press the handle release lever to move handle to the operat-

ing or middle position.

Push bolt (K) into hole on lower front of handle.

If bolt will not go through hole easily, handle is not pushed com- pletely down.

13

L

NUT

13Place nut in recessed area (L) at back of handle. Hold nut

in place while tightening bolt secure- ly with a screw driver.

Note: Only one nut is needed on this model. The extra nut is not required but has been provided for your convenience.

14

M

14On upper front handle, grasp bag clip (M) and pull down

firmly. Hook bag clip into slot in bag cap.

15

N

O

15Pull switch lock (N) above ON/OFF switch (O) straight

out. Dispose of lock.

Note: If tab has come off during assembly, make sure switch is in the OFF position (down) before plugging cord into an electrical outlet.

4