Hoover HND 7515, Nextra Dishwasher Water connection, Connecting the outlet hose, “A”, “B”, “D”, “B”, “A”, “C”, (fig. 2), (fig. 3), (fig. 4), IMPORTANT, IMPORTANT, (fig. 4X), (fig. 4Y), (fig. 4Z)

Water connection

IMPORTANT

The appliance must be connected to the water mains using new hose-sets. The old hose-sets should not be reused.

■The inlet and drain hoses can be directed to left or right.

IMPORTANT

The dishwasher can be connected to either cold or hot water, as long as it is no hotter than 60 °C.

■Water pressure must be between 0,08 MPa and 0,8 MPa. If the pressure is below the minimum consult our service department for advice.

■The inlet hose must be connected to a tap so that the water supply can be cut off when the machine is not in use

(fig. 1 B).

■The dishwasher is fitted with 3/4" threaded connector (fig. 2).

■Connect inlet hose “A” to water tap “B” with a 3/4" attachment making sure that it has been properly tightened.

■If it is necessary, the inlet pipe can be lengthened up to 2,5 m. The extension pipe is available from the After Sales Service Centre.

■If limescale deposits or sand are present in the water, it is advisable to obtain the appropriate filter, art. 9226085, from the After Sales Service Centre (fig. 3). The filter “D” must be inserted between the tap “B” and the inlet hose “A” , remembering to fit the washer “C” .

■If the dishwasher is connected to new pipes or to pipes which have not been in use for a long time run water through for a few minutes before connecting the inlet hose. In this way no deposits of sand or rust will clog up the water inflow filter.

Connecting the outlet hose

■The outlet hose should disharge into a standpipe, making sure that there are no kinks (fig. 4).

■The standpipe must be at least 40 cm above floor level and it must have an internal diameter of at least 4 cm.

■It is advisable to fit an anti-odour air trap (fig. 4X).

■If necessary the outlet hose can be extended up to 2,5 m, provided that it is kept at a maximum height of 85 cm above floor level. The extension pipe is available from the After Sales Service Centre.

■The hose can be hooked over the side of the sink, but it must not be immersed in water, in order to prevent water from being syphoned back to the machine when this is in operation (fig. 4Y).

■When installing the appliance under a worktop the hose pipe clamp must be attached to the wall in the highest possible position under the worktop (fig. 4Z).

■Check that there are no kinks in the inlet and outlet hoses.