INSTALLATION IN FITTED KITCHENS

Fitting between existing cabinets

■The height of the dishwasher, 85 cm, has been designed in order to allow the machine to be fitted between existing cabinets of the same height in modern fitted kitchens. The feet can be adjusted so that correct height is reached.

■The laminated top of the machine does not require any particular care since it is heatproof, scratchproof and stainproof (fig. 5).

Underneath existing work top

(when fitting beneath a work top)

■In most modern fitted kitchens there is only one single work top under which cabinets and electrical appliances are fitted. In this case remove the work top of the dishwasher by unscrewing the screws under the rear edge of the top (fig. 6a).

IMPORTANT

After removing the work top, the screws MUST BE screwed again under the rear edge of the top (fig. 6b).

■The height will then be reduced to 82 cm, as scheduled by the International Regulations (ISO) and the dishwasher will fit perfectly under the kitchen working top (fig. 7).

WATER SOFTENER UNIT

Depending on the source of the supply, water contains varying amounts of limestone and minerals which are deposited on the dishes leaving whitish stains and marks.

The higher the level of these minerals present in the water, the harder the water is. The dishwasher is fitted with a water softener unit which, through the use of special regenerating salt, supplies softened water for washing the dishes. The degree of hardness of your water can be obtained from your water supply company.

Regulating the water softener with electronic programmer

The water softener can treat water with a hardness level of up to 90°fH (French grading) or 50°dH (German grading) through 8 settings.

The settings are listed in the table below:

*The softener unit is set in the factory at level 4 (d4) as this satisfies the requirements of the majority of users.

Regulate the setting of your water softener unit according to the degree of hardness of your water as follows:

1.Keep the "DELAY START" button pressed in and at the same time press

the "ON/OFF" button .

The factory setting "d4" will appear on the display.

2.To change the setting, press the "DELAY START" button. Each time you press that button the setting will increase by one level.

When you have reached "d7", the display will go back to "d1".

3.When the required setting appears on the display, wait for an audible signal to confirm that the new setting has been stored in memory.

5

6

a

7

a

 

 

b

 

 

 

b

 

598

556/573

Opening the door

 

Closing the door

 

Water

 

 

 

hardness
Use of
Water
Level

 

 

regenerating
softener
°fH
°dH

 

salt
setting

 

(French)
(German)

 

 

 

0

0-5

0-3

NO

d1

1

6-10

4-6

YES

d1

2

11-20

7-11

YES

d2

3

21-30

12-16

YES

d3

*4

31-40

17-22

YES

d4

5

41-50

23-27

YES

d5

6

51-60

28-33

YES

d6

7

61-90

34-50

YES

d7

 

 

 

 

 

Put your hand into the recess and pull.

If the machine comes open while it is working, an electrical safety device automatically switches everything off.

IMPORTANT

For the machine to work properly, the door should not be opened while it is in operation.

Place the baskets in the machine.

Make sure that both the spray arms are free to rotate and are not obstructed by cutlery, crockery or pans. Close the door, pressing on it to make sure it is firmly shut.

Digital display

“ON/OFF”

“DELAY START”

button

button

 

8

9