Hoover Plus owner manual Attach upper handle, Attach hose holder, W n

Assemble handle 1-3

The assembled cleaner will look like this drawing (Plus model shown).

1-2

A

Attach upper handle

Remove clean solution tank (upper tank) from deep cleaner.

With cord hook (A) to back of deep cleaner, push upper handle down onto lower han- dle. Push b o l t s into holes on front of han- dle. If bolts will not go through hole easi- ly handle is not pushed completely

d o w n .

1-4 1-5 1-6

B

C

Attach hose holder

Position hose holder (B) onto handle by matching tabs on rack with openings on back of handle. Make sure holes for bolts are aligned.

Place nuts in recessed areas on back of the hose holder. Hold each nut in place while tightening each bolt securely (from the front of the handle) with a Phillips screwdriver.

Only two nuts are needed on this model. The extra nut is not required but has been provided for your convenience.

When handle sections are completely together, squeeze trigger (C) on upper handle to snap trigger rod In place.

1-7 1-8 1 - 9

Replace clean solution tank (upper tank) by positioning bottom first. Press on tank handle to snap top of tank into place.

Press cord into cord clip on back of handle. Pull cord tight.

Attach tool holder

Remove tool and taped screw from holder.

Insert projections on rack into slots on back of cleaner.

4