AGITATOR BRUSHES
When to replace brushes
To check condition of brushes, place edge of a card on the bot- tom of nozzle base, across agita- tor opening. Rotate agitator by hand. If brushes do not touch edge of card, all four brushes and brush roll should be replaced to maintain cleaning effectiveness.
When replacing agitator brushes, ask for HOOVER part No.
48445017.
How to replace agitator brushes
Disconnect cleaner from elec- trical outlet and disconnect power nozzle from extension wands.
Remove nozzle cover, agitator and belt following directions in “How to replace belt” section.
1, Hold agitator as shown. Turn end plates counterclockwise until one end plate comes off.
2.Pull or pry out end sections as shown in illustration.
Note: Pulley end should be re- moved by pulling straight out.
16
