3. Note position of
.
1
/
ment.
Remove
/
The word “BAR” is stamped near the slots on the agitator.
Match the bar side of the bar brush assembly with the label on the agitator shell. Slide the new assemblies into the slots, while twisting the assemblies in a coun- terclockwise motion. Push in as far as possible, tapping the other end lightly if necessary. Be sure brushes and bars are aligned for full length of agitator.
4.Reassemble agitator parts. Line up locator on end sections with slot on agitator. Push end sections into position.
Screw on end plates and tighten.
5.Should you accidentally dis- place the bearing during disas- sembly, reassemble as shown.
Replace belt, agitator and nozzle cover.
END SECTION
Lubricatiori
The motor is equipped with one ball bearing and one sleeve bearing. These bearings contain sufficient lubrication for the life of the motor. The addition of lubricant could cause damage. Therefore, do not add lubricant to either motor bearing.
The agitator is equipped with two ball bearings that should be lubricated periodically. This should be done by a Hoover Factory Service Center or an Authorized Hoover Warranty Service Dealer.
17
