Hoover Slider Vacuum Cleaner Service, Lubrication, If you have a problem, Possible solution

14	G	H
	F

connector straight in until you hear a click. Return battery pack and termi- nal into unit.

Replace battery door by first insert- ing tab (F) on bottom of door and positioning hole (G) on door with hole (H) on unit. Replace screw and tighten with screwdriver

Dispose of battery pack in accor- dance with your state’s laws.

The EPA certified RBRC® Battery Recycling Seal on the nickel-cadmi- um (Ni-Cd) battery indicates The Hoover Company is voluntarily par- ticipating in an industry program to collect and recycle these batteries at the end of their useful life, when taken out of service in the United States or Canada. The RBRC® pro- gram provides a convenient alterna- tive to placing used Ni-Cad batter- ies into the trash or the municipal waste stream, which may be illegal in your area. Please call 1-800-8- BATTERY™ for information on Ni-Cd battery recycling and disposal bans/restrictions in your area.

The Hoover Company’s involvement in this program is part of our com- mitment to preserving our environ- ment and conserving our natural resources.

Service

To obtain approved Hoover Service and Genuine HOOVER parts, locate the nearest Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot) by:

•checking the Yellow Pages under “Vacuum Cleaners- Household” OR -

•checking the list of Factory Service Centers provided with this cleaner OR -

•checking the Service section of The Hoover Company on-line at www.hoover.com OR -

•calling 1-800-944-9200for an automated referral of authorized

service outlet location (U.S. only). Do not send your cleaner to The

Hoover Company in North Canton for service, this will only result in delay.

If further assistance is needed, con- tact The Hoover Company Consumer Response Center, North Canton, Ohio 44720,

Phone: 1-330-499-9499.

In Canada, contact Hoover Canada, Burlington, Ontario L7R 4A8, Phone: 1-800-263-6376.

Always identify your cleaner by the complete model number when requesting information or ordering parts. (The model number appears on the bottom of the cleaner.)

Lubrication

Lubrication is not necessary since the motor and brush roll bearings are permanently lubricated.

If desired, you may contact your local Hoover Factory Service Center for battery pack replacement.

If you have a problem

If a minor problem occurs, it usually can be solved quite easily when the

Problem: Cleaner won’t run list below.

Possible Cause

Possible solution

•Charger not firmly plugged in

•Plug charger in firmly

•Battery not charged

•Recharge battery making sure cleaner is fully connected to end of cord

•No voltage in wall plug

Problem: Cleaner won’t pick up

•Check fuse or breaker

•Blown fuse or tripped breaker

•Replace fuse/ reset breaker

Problem: Charging light not lit when plugged in

Possible Cause

Possible solution

•Cleaner not firmly plugged in

•Plug charger in firmly

5