The assembled cleaner will look like this |
| ||
drawing. |
|
|
|
|
|
|
A
Attach upper handle
Remove clean solution tank (upper tank) from deep cleaner.
B
Remove nozzle stored on upper handle by gently pushing nozzle downward while pivoting it away from the handle at
(A).
With cord hook (B) to back of deep cleaner, push upper handle down onto lower handle.
Push b o l t s into holes on front of handle. If bolts will not go through hole easily, handle is not pushed completely down.
Place nuts in recessed areas on back of handle. Hold each nut in place while tightening each bolt securely with a Phillips screwdriver. Only two nuts are needed on this model. The extra nut is not required, but has been provided for your convenience.
1 - 8 | 1 - 9 |
D
C
When handle sections are completely together, squeeze trigger (C) on upper handle to snap trigger rod in place.
Replace clean solution tank (upper tank) by positioning bottom first. Press on tank handle (D) to snap top of tank into place.
Press cord into cord clip on back of handle. Pull cord tight.
4
