Attention: if the filter needs cleaning while there is washing still in the drum, follow the instructions on the following page to empty the water. This will prevent excessive loss of water via the filter.

Cleaning the door glass

Regularly clean the door glass with a damp cloth. A build up of soiling and

residues from the water may result in water leaking from the door.

Do not use abrasive cleaners as they can scratch the surface.

Transporting the appliance or long periods when appliance is not in use

If the appliance is being transported or is out of use for long periods in unheated places, all remaining water must be completely removed from the hoses.

Ensure mains power is off, then unclip the hose and point it downwards into a basin until all the water has emptied out.

When finished, repeat the operation in the reverse order.

Investigating malfunctions

What might be the cause of…

Defects you can remedy yourself

 

MALFUNCTION

CAUSE

 

REMEDY

 

1.

Does not work on any

Plug not in socket.

 

Plug it in.

 

programme

Not switched on.

 

Switch on.

 

 

 

Power failure.

 

Check.

 

 

 

Fuse blown.

 

Check.

 

 

 

Door open.

 

Close door.

 

 

 

 

 

 

 

2.

Does not fill with water

See cause 1.

 

Check.

 

 

 

Tap turned off.

 

Turn on tap.

 

 

 

Programme selector not correctly positioned.

Position programme selector correctly.

 

 

 

Fill hoses are kinked

 

Straighten fill hoses

 

 

 

 

 

 

 

3.

Water does not drain away

Kink in discharge hose.

 

Straighten discharge hose.

 

 

 

Foreign bodies in filter

 

Examine filter (see pages 23-24)

 

 

 

House drain is blocked

 

Clean drain

 

 

 

 

 

 

4.

Water on floor around the

Leaking gasket between tap and water inlet

Replace gasket and tighten hose and tap

 

washing machine

hose.

 

well.

 

 

 

House drain is blocked

 

Clean drain

 

 

 

Soap drawer blocked with soap residues

Clean soap drawer

 

 

 

 

 

 

5.

Does not spin

Water has not yet drained away.

Wait a few minutes for machine to empty.

 

 

 

"No spin" selected (certain models only).

Reset button or turn "no spin" knob.

 

 

 

 

 

 

6.

Machine vibrates a lot

Washing machine not completely level.

Adjust the special adjustable feet.

 

during spin

Transit brackets not removed yet.

Remove transit brackets.

 

 

 

Load not distributed evenly.

 

Rearrange the laundry evenly.

 

 

 

 

 

 

7.

Door will not open

Two minutes have not elapsed since the

Wait two minutes.

 

 

 

programme finished.

 

 

 

 

 

 

 

 

 

 

 

8.

Display reads error

 

 

 

 

Call service.

 

0, 1, 5, 7, 8

 

 

 

 

 

 

 

 

 

9.

Display reads error 2

No water fill.

 

Check water supplies are on.

 

 

 

 

 

 

10. Display reads error 3

No pump out.

 

Check drain is clear.

 

 

 

 

 

 

 

Check drain hose is not kinked.

 

 

 

 

 

11. Display reads

Machine overfilled with water.

Turn off water supply to machine.

 

 

error 4

 

 

 

 

Call service.

 

12. Display reads

 

 

 

 

Cancel the programme by returning the

 

 

error 9

 

selector to the OFF position.

 

 

 

 

 

 

 

Select again the programme and press

 

 

 

 

 

 

 

the START/PAUSE button to switch the

 

 

 

 

 

 

 

machine on.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

The machine makes a

 

 

Only a small level of water can be

 

different noise when

 

 

seen in the drum! This is because

 

spinning! This is because it

 

 

new machines do not use much

 

has a brush motor for better

 

 

water, yet achieve the same standard

 

performance.

 

 

 

of washing and rinsing.

 

 

 

 

 

 

 

 

24

25