Assembly

UNPACKING

Unpack the product where you will be using it. Place the product on a level flat surface. It is recom- mended that you place a protective covering on your floor. Note: It is recommended that you apply grease to the threads of each bolt as you assemble the product, to prevent loosening and noise. Also, during each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before completely tightening any ONE bolt.

FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY! Place your elliptical trainer on a level flat surface. It is recommended that you place a protective covering on your floor.

Parts (see illustration on previous page)

1 Front Foot Tube

2 Upper Handlebars

2 Lower Handlebars/Link Arms

2 Pedal arms

2 Guide Rails

1 Console Mast

1 Console Mast Boot

1 Power Supply

2 Pedal Arm Sleeves

2 Crank Boots

2 Front Upper Handlebar Covers

2 Back Upper Handlebar Covers

1 Hardware Pack (contents listed below)

Tools (included)

4mm Allen Wrench

5mm Allen Wrench/ Phillips Screw Driver

13/15mm Flat Wrench

17mm Wrench

CONTACT HORIZON FITNESS CUSTOMER ASSISTANCE CENTER; TOLL FREE @ 1-800-244-4192 OR VISIT www.horizonfitness.com

8

Page 8
Image 8
Horizon Fitness E6050 manual Assembly, Unpacking