Hotpoint BFQ 700 manual Installation, Positioning and levelling, Technical data, Equipment WEEE

Installation

EN	￿ Keep this instruction manual in a safe place for
	future reference. If the appliance is sold, given away
	or moved, please ensure the manual is kept with the
	machine, so that the new owner may benefit from the
	advice contained within it.
	￿ Please read this instruction manual carefully: it
	contains important information regarding the safe
	installation, use and maintenance of the appliance.
	￿ If the appliance must be moved at any time, keep it
	in an upright position; if absolutely necessary, it may
	be tilted onto its back.

Positioning and levelling

1. Remove the appliance from all packaging and check that it has not been damaged during transportation.

If it has been damaged, contact the retailer and do not proceed any further with the installation process.

2. Check the dishwasher by placing it so that its sides or back panel are in contact with the adjacent cabinets or even with the wall. This appliance can also be recessed under a single worktop (see the Assembly instruction sheet).

3. Position the dishwasher on a level and sturdy floor. If the floor is uneven, the front feet of the appliance may be adjusted until it reaches a horizontal position (the angle of inclination must not exceed 2 degrees). If the appliance is levelled correctly, it will be more stable and much less likely to move or cause vibrations and noise while it is operating.

4. Adjust the height of the rear feet from the front of the appliance*: use a screwdriver to tighten or loosen the screws on the lower part of the dishwasher.

Anti-condensation strip*

After installing the dishwasher, open the door and stick the adhesive transparent strip under the wooden shelf in order to protect it from any condensation that may form.

Advice regarding the first wash cycle

After the appliance has been installed, immediately before running the first wash cycle, completely fill the salt dispenser with water and add approximately 2 kg of salt (see Rinse aid and refined salt). The water may overflow: this is normal and is not a cause for concern. It is also normal that the LOW SALT* indicator light continues to flash for a few cycles after the salt has been loaded.

Technical data

Dimensions	width 59.5 cm
	height 82 cm
	depth 57 cm
Capacity	12 standard place-settings
Water supply	30 Kpa ÷ 1Mpa (0.3 ÷ 10 bar)
pressure	4.3 psi – 145 psi
Power supply	See appliance data plate
voltage
Total absorbed	See appliance data plate
power
Fuse	See appliance data plate
	This dishwasher conforms to
	the following European
	Community Directives:
	-73/23/EEC dated 19/02/73
	(Low Voltage) and subsequent
	modifications
	-89/336/EEC dated 03/05/89
	(Electromagnetic Compatibility)
	and subsequent modifications
	-97/17/EC (Labelling)
	-2002/96/ CE Waste
	Electrical and Electronic
	Equipment (WEEE)

* Only available in selected models.

2