Sink Waste System
For under sink drainage:
•before connecting the drain hose, remove any internal restrictions; this will prevent a build up of debris which could cause a blockage
•remove any restrictions from the waste spigot and ensure that the sealing bung is removed
•the hose should be routed, such that it is raised to a minimum height of 800mm (31/2”).
Ensure the sink outlet pipe has a minimum diamtere of 32mm.
•Untie the end of the GREY drainage hose from the rear of the appliance.
•Reposition the ‘Hooked End Support’ as required along the GREY drainage hose.
•If fitting an under sink waste disposal unit, cut out the membrane, bung or blanking plug.
Ensure the drain hose is securely attached, to prevent it coming away while the machine is in use and causing a flood.
Anti-flooding protection*
EN
To ensure floods do not occur, the dishwasher:
-is provided with a special system which blocks the water supply in the event of anomalies or leaks from inside the appliance.
-is provided with a Water Stop* safety device, in other words it has a water inlet hose that consists of a transparent hose on the outside and a red hose on the inside: both the hoses can withstand extremely high pressure. If the internal hose breaks, the external hose becomes a bright red colour and carries the water instead, thus avoiding any leakage.
It is very important to check the external hose regularly: if it is a bright red colour, it must be replaced by an authorised technician as soon as possible (see Assistance).
* Only available in selected models.
5
