D ISHWASHER
INFORMATION FOR TEST LABS
Load for 12 Standard Settings tests (upper rack at top position)
Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the ‘Programme Chart’. The detergent dispenser is located on the inside panel of the door.
Loading the DetergentTo open lid ‘A’ press button ‘B’. The cleaning detergent should be introduced into the three containers ‘1’, ‘2’ and ‘3’ (See table at the end of the page).
After pouring in the detergent, replace the lid, pressing down until it clicks.
This product makes dishes sparkle more as it improves their drying. The rinse aid container is situated on the inside of the door; it should be filled up when the rinse aid indicator light “T” flashes.
Loading the Rinse AidTo open the dispenser turn cap C in the anticlockwise direction and then pour in the rinse aid making sure not to overfill. The amount of rinse aid used for each cycle can be regulated by turning the dose adjuster ‘F’ which you will find under lid ‘C’. There are 6 different settings, the normal dosage is setting 5.
Thisbasketisequippedwithtworemovablegrids:insert the cutlery one by one into the slots, with the handles at the bottom. Position them so that they don't touch.
BD
F
Comp1 Comp2 Comp3
C
A
| Cycle |
EN 50242 | See booklet * |
IEC/ DIN | See booklet * |
Total detergent
30gr.
30 gr.
Comp.1
10
Comp.2
25
20
Comp.3
5
*Select the Normal or daily wash cycles (See Programme Chart in the instruction booklet) and press the “extra dry button, if existing
14
