Hotpoint CTF19, CTF17 manual Earai~ces, Tik’x%atexelTsioE3Cxwrk$, Location, Out

f ~r(!n <-$ .t:+dgw~: - %!

‘J43U d\ Gtibf>wi $.? L@

!3ecauseof potential safety hazards under cwtain conditions, we strongly recommendagainstuseof anadapter plug. However, if you still elect to use anadapter,where iocal codes permit, aTEMPORARYCONiNECTION may be madeto a properly grounded two-prong wail receptacle by use of a IJL listed adapter (Fig. 2) available at most local hardware stores.

tik’x%atex:elTsioE3Cxwrk$

Because of potential safety hazards under certain conditions, we strongiy recommend against the use of an extension cord. However, if you still elect to use an extension cord, it is absolutely necessarythat it be a U!- listed 3-wire grounding ty~e appli- ance extension cord and that the current carrying rating of the cord be 15 amperes minimum. Such exten- sion cords are obtainable through your local service organization.

Adjustablercd$em[on modelsso eauiooed) which enable vou to kov~-refrigerator awayfrtim wall for cieanirm, or leveling legs, are located-behind has=gr;lle. They should beset so refrigerator is firmly positioned on fioorand front is raisedjust enough that doors close easily when opened about halfway.

—

e.

The k+mgerslotin the adapter must be aligned with the Iargerslot in the wall receptacle to provide proper polarity in the connection of the power cord.

CAUTK2N: Attaching adapter ground terminal to wail receptacle cover screw does not ground the appliance unless cover screw is metal, and not insulated, and wall receptacle is grounded through house wiring. Customer should have the circuit checked by a qual- ified electrician to make sure the receptacle is properly grounded.

When disconnecting the power cmrcifrom the adapter, always hold the adapter with one hand. If this is not done, the adapter ground terminal is very likely to break with repeated use.

should the adapter ground terminal break, DO NOT USE the app!iarlce until a proper grcNJnd has again been established.

This is recommended for best performance and to prevent over- loading house wiring circuits, which could cause a possible fire hazard from overheating wires.

Location

Do not install refrigeratorwhere temperaturewill go below 60°F.

because it will not run often enough to maintain proper temperatures.

Do installit cma floor strongenough

R3supporta fully loadedrefrigerator.

Also see Energy-Saving Tips regarding location.

c!earai~ces

Nkxw 5/8” at each sick?and1“ over the top for ease of installationand proper air circulation.

;;P

-iw-xmQd(wlgPk. ;?2r$evif mcmw . * .

consider providing water supply to refrigerator iocation. It will simplify connection of optional automatic icemaker should you wish to install one at a later date.

k!OUT

Toadjustrollersor kwe!inglegs, remove base grille by grasping it at bottom and pulling it straight out.

I ROLLER I i I

1!

Turn roller adjusting screws or leveling legs clockwiseto raise refrigerator, counterclockwise to kxww it. Use adjustable wrench or pliers 017the roller adjusting screw’s 3/811hex head bolt.

When adjusting rollers or leveling legs for proper door closure, bottom front edge of cabinet should be approximately 5/8” from floor.

\d..

on back of grille with clamps in cabinet and gently push ‘forward

until grille snaps into place. (-}:)i’ “...Y,-,

—...— .—.—...——