Timer Operation (EG54)
0.00
0.00
19.50
1.41
Here you can set a time period of up to 10 hours, that will count down. When it reaches zero, the timer will emit an audible tone.
For Example: If you set 20 minutes, the audible tone will occur 20 minutes later.
SETTING THE MINUTE MINDER
Step 1 Ensure the time of day is set correctly.
Step 2 Press and release the ‘+’ button.
Note: Step 3 must be started within 10 seconds, otherwise you must repeat Step 2.
Step 3 Press the ‘+’ button to set the required time period. A ‘Bell’ symbol will light up.
The time period can be adjusted, by using the ‘+’ button to increase the time period or the
Release all buttons, the timer display will show the remaining time period. The ‘Bell’ symbol will remain lit to signify that a time period has been set.
At the end of the set time an audible tone will be heard and the ‘Bell’ symbol will disappear.
Step 4 To cancel the audible tone press the ‘+’ button.
To cancel the minute minder period press the
If at any time the display shows flashing zero’s, it is likely that the electricity supply has been interrupted.
Reset the timer to the correct time of day.
Note: The Timer display will show the minute minder period as follows:
Any period up to 99 minutes and 50 seconds -
The display shows MINUTES and SECONDS (10s intervals) eg. 19 minutes 50 seconds
Any period between 100 minutes (1 hour 40 minutes) and up to 10 hours -
The display shows HOURS and MINUTES eg. 1 hour 41 minutes
13
