Care and Cleaning
CLEANING THE DOORS
Take particular care not to damage the inner surface of the door inner glass that is coated with a heat reflective layer. Do not use scouring pads, or abrasive powder,which will scratch the glass. Ensure that the glass panel is not subjected to any sharp mechanical blows. Stubborn stains can be removed by using a fine steel wool soap pad. For slight soiling theinner glass panel may be cleaned, while still warm, without removing it from the door. Aftercleaning, rinse and dry with a soft cloth.
SIDE OPENING DOORS
DROP DOWN DOORS
Cleaning the door glass is the same as the drop down doors, except take care to support the weight of the inner glass when removing and refitting.
Remove the door inner glass as follows.
1.Open the door fully and remove the extrusion end caps (This should be done by hand but if it proves too difficult, simply lift the inner glass to ease the end caps out of position).
NOTE: If you need to use a tool - be careful not to damage the extrusion or end cap.
2.Carefully slide the inner glass towards you andwithdraw it from its locating slots. Ensure that the door is not allowed to slam shut, due to the reduction in door weight. Clean the glass as described above.
3.The inside of the outer door glass can now be cleaned while still fitted to the cooker.
NEVER OPERATE THE COOKERWITHOUT THE INNER DOOR GLASS IN POSITION.
Refit the door inner glass as follows.
1.Open the door fully.
2.Locate the inner door glass into its slots, so that the printing is readable from the face nearest the oven in the closed position and the widest black band is towards the bottom of the door. The inner door glass has a special reflective coating on one side, in order to minimise surface temperatures and energy consumption during use, it is important it is fitted correctly.
3.Carefully slide the glass into its slots as far as it will go and replace the end caps.
22
