GB Maintenance and care
Switching the appliance off
Disconnect your appliance from the electricity supply before carrying out any work on it.
Cleaning the appliance
!Do not use abrasive or corrosive detergents such as stain removers,
!Never use steam cleaners or pressure cleaners on the appliance.
•It is usually enough to wash the hob with a damp sponge and dry it with absorbent kitchen roll.
•The removable parts of the burners should be washed frequently with warm water and soap and any
•For hobs which ligth automatically, the terminal part of the electronic instant lighting devices should be cleaned frequently and the gas outlet holes should be checked for blockages.
•Stainless steel can be marked by hard water that has been left on the surface for a long time, or by aggressive detergents containing phosphorus. After cleaning, rinse and dry any remaining drops of water.
!It is not necessary to remove the pan supports in order to clean the hob surface. Thanks to the support system, simply lift and hold the pan supports or rotate them until they rest against a rear support.
Clening tips for the hotplates with logo
To remove all types of stains just wipe with a smooth cloth, wet with hot water. For stronger stains, we recommend the use of common detergent for dishes, with a cloth dampened with hot water, to ensure a perfect cleaning result.
!Never use aggressive detergents or coarse sponges because they can cause irreversible damage to the special protection treatment with formation of irremovable stains and halos.
Gas tap maintenance
Over time, the taps may become jammed or difficult to turn. If this happens, the tap must be replaced.
!This procedure must be performed by a qualified technician authorised by the manufacturer.
Troubleshooting
It may happen that the appliance does not function properly or at all. Before calling the service centre for assistance, check if anything can be done. First, check to see that there are no interruptions in the gas and electrical supplies, and, in particular, that the gas valves for the mains are open.
The burner does not light or the flame is not even around the burner.
Check whether:
•The gas holes on the burner are clogged.
•All the movable parts that make up the burner are mounted correctly.
•There are draughts near the appliance.
The flame dies in models with a safety device.
Check to make sure that:
•You pressed the knob all the way in.
•You keep the knob pressed in long enough to activate the safety device.
•The gas holes are not blocked in the area corresponding to the safety device.
The burner does not remain lit when set to minimum.
Check to make sure that:
•The gas holes are not blocked.
•There are no draughts near the appliance.
•The minimum setting has been adjusted properly.
The cookware is unstable.
Check to make sure that:
•The bottom of the cookware is perfectly flat.
•The cookware is positioned correctly at the centre of the burner.
•The pan support grids have been positioned correctly.
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
12
