Before you call for service… | Hotpoint.com |
Troubleshooting Tips
Save time and money! Review the charts on the following pages, or visit Hotpoint.com. You may not need to call for service.
Problem | Possible Causes | What To Do |
Dishwasher | Fuse is blown, or the | • Replace fuse or reset circuit breaker. Remove any other appliances |
won’t run | circuit breaker tripped | from the circuit. |
|
|
|
Noise | Some of the sounds | • Soft food disposal shredding action. |
| you’ll hear are normal | • Drain valve opening to pump water out. |
|
| • Timer control as cycle progresses. |
|
| • Detergent cup opening. |
|
| • The motor stopping during the drying period. |
|
|
|
| Utensils are not secure | • Make sure everything is secured in dishwasher. |
| in the rack or something |
|
| small has dropped into |
|
| the rack |
|
|
|
|
| Motor hums | • Dishwasher has not been used on a regular basis. If you do not use |
|
| your dishwasher often, set it to fill and pump out once every week. |
|
| This will help keep the seal moist and the garbage disposer clear. |
|
|
|
Water standing in | This is normal | • A small amount of clean water around the outlet on the tub bottom |
the bottom of the tub |
| at the back of the tub keeps the water seal lubricated. |
|
|
|
Water won’t pump | Drain is clogged | • If you have an air gap, clean it. |
out of the tub |
| • Check to see if your kitchen sink is draining well. If not, you may need |
|
| a plumber. |
|
| • If the dishwasher drains into a disposer, run disposer clear. |
|
|
|
Suds in the tub | Correct detergent | • Use only automatic dishwasher detergents to avoid sudsing. Cascade®, |
| wasn’t used | Cascade® Complete and Electrasol® Automatic Dishwashing |
|
| Detergents have been approved for use in all GE dishwashers. |
|
| • To remove suds from the tub, open the dishwasher and let suds |
|
| evaporate. Add 1 gallon of cold water to the tub. Close and latch the |
|
| dishwasher. Pump out water by slowly turning the Dial until a drain |
|
| period is reached. Repeat if necessary. |
|
|
|
| Rinse agent | • Always wipe up rinse agent spills immediately. |
| was spilled |
|
|
|
|
Stained tub interior | Detergent with | • Some detergents contain colorant (pigment or dyes) that will discolor |
| colorant was used | the tub interior with extended use. Check the detergent cup for signs |
|
| of any discoloration. If cup is discolored, change to detergent without |
|
| any colorant. Cascade®, Cascade® Complete and Electrasol® |
|
| Automatic Dishwashing Detergents have been approved for use |
|
| in all GE dishwashers. |
|
|
|
| Some | • Use of the RINSE ONLY cycle (on some models) after adding the dish to |
| foods can stain | the load can decrease the level of staining. |
|
|
|
Dishes don’t dry | Low inlet water | • Make sure inlet water temperature is correct. |
| temperature |
|
|
|
|
| Rinse agent dispenser | • Check the rinse agent dispenser. |
| is empty |
|
11
Safety Instructions
Operating Instructions
Troubleshooting Tips
Consumer Support