Hotpoint HDA969 warranty How to operate your dishwasher, For RINSE & HOLD cycle

Models: HDA969

1 20
Download 20 pages 61.61 Kb
Page 4
Image 4
How to operate your dishwasher

How to operate your dishwasher

POTS* NORMAL ,, G,, WATER HEAT DR,,,G HEAT

P,., WAS” WASH ,, 0,, ON OFF

>’

STEP 1. Load your dishwasher with dishes, silverware, pots, pans, bowls, etc., according to instructions on pages 8 and 9.

STEP 2. Add detergent to the detergent dispenser. Make sure the Cyc!e Indicator Dial is at OFF position before adding detergent. (See pages 6 and 7.)

Use rinse aid agent to help prevent spotting. Occasionally check to insure that rinse agent container is at least half full. (See page 6.)

STEP 3. Select DRYING HEAT option. It must be ON for PLATE WARMER cycle, OFF for RINSE

&HOLD cycle. It can be ON or OFF at your option (see below), for any of the wash cycles.

DRYING HEAT

DN DFF

m

DRYING HEAT ON: Turns the drying heater on for fast drying.

DRYING HEAT OFF: Turns the drying heater off to save energy. Dishes will dry naturally over a longer period such as overnight.

If you need your dishes sooner, open the dishwasher door after the cycle is complete to reduce the natural drying time.

Use of this option reduces the electrical energy used by this model approximately 10~o for the NORMAL WASH cycle.

STEP 4. WATER HEAT Option.

WATER HEAT

ON OFF

m

ON: The wash cycle will be extended for 9 minutes while the

dishwasher heats the water for good washing and drying. The entering water must be at least 120°F.

OFF: The entering water must be at least 140°F. To test water temperature, see page 6.

STEP 5. Select the wash cycle and start the dishwasher. (See Cycle Selection Hints at right.)

If your dishwasher drains into a food waste disposer, operate the disposer until it is empty before starting the dishwasher.

To obtain the benefits of a complete cycle, be careful that you do not turn the dial any further than necessary to start the dishwasher.

For POTS & PANS, NORMAL WASH and LIGHT WASH cycles:

POTS & NORMAL LIGHT

PANS WASH WASH

a. Push selected cycle button.

b. Latch the door.

c.Slowly turn Cycle Indicator Dial to ON position to start the cycle. You will hear the motor start. There is a time delay between start-up and water fill so you will not hear any wash action right away.

For RINSE & HOLD cycle:

 

wash,ng

ON .

 

 

OFF

.

RINSE

)

k HOLD

(

ed~(ng

ORYIPLAIEWARMFR

a.Be sure door is unlatched.

b.Select DRYING HEAT OFF drying option.

c.Slowly turn Cycle Indicator Dial to RINSE& HOLD position.

d.Latch the door to start the cycle.

4

Page 4
Image 4
Hotpoint HDA969 How to operate your dishwasher, For POTS & PANS, NORMAL WASH and LIGHT WASH cycles, For RINSE & HOLD cycle