Control Panel
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
MAIN | GRILL ELECTRONIC* LEFT | LEFT | RIGHT | RIGHT | ||||||||
OVEN |
| INIECTION | FRONT | REAR | REAR | FRONT | ||||||
| BURNER | BURNER | BURNER | BURNER | ||||||||
|
|
| BUTTON | |||||||||
|
|
|
|
|
|
|
|
|
|
| ||
Control Knobs for the gas burners
The position of the gas burner controlled by each one of the knobs is shown by a solid ring •. To light one of the burners, hold a lighted match or lighter near the burner and, at the same time,
press down and turn the corresponding knob counter clockwise to the maximum
setting. Each burner can be operated at its maximum, minimum or intermediate power. Shown on the knob are the different symbols for off • (the knob is on this setting when the symbol corresponds with the
reference mark on the control panel), for maximum 
and minimum 
. To obtain these settings, turn the knob counter clockwise with respect to the off position. To turn off the burner, turn the knob clockwise until it stops (corresponding again with the • symbol).
Electronic Ignition
for the Gas Hob*
This device operates when a slight pressure is applied to the button marked with 
symbol.To light a
specific burner just press the button 
while pushing the corresponding knob all the way in and turning it
turn the knob.
Important: Should the burner flames accidentally go out, turn off the control knob and wait at least 1 minute before trying to relight.
Models with Hob Gas Burner Safety Devices to Prevent Leaks *
These models can be identified by the presence of the device itself.
Important: Since the hob burners are equipped with a safety device, you must hold the control knob in for about 3 seconds after the burner has been lighted to allow the gas to pass until the safety thermocouple has heated.
* (only available on certain models)
12
