—17—
PROCEDURE B CONTINUED
Remove the backing from the support blocks and attach
them to the inside of the wall sleeve as shown FIG 29.
Slide the baffle into slots of the support blocks.
Install the new unit into the wall sleeve.
Assemble trim as described in Step 6,
Procedure A.
8
Wall
Wall
Sleeve Baffle
(
7
3/32
"
)
Front Support
Block
FIG. 29
6
7
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people are
needed to move and install the unit.
To prevent injury or strain, use proper lifting and carrying
techniques when moving unit.
• When handling the air conditioner, be careful to avoid
cuts from sharp metal fins on front and rear coils.
• Make sure air conditioner does not fall during removal.
• If unit does not operate after installation check, to be sure
the circuit interrupter has not been tripped. Refer to the
Troubleshooting guide for reset procedure.
CAUTION