Hotpoint LT143CNR 7, Parts and Installation, PROCEDURE C CONTINUED, 8, 9

—19—
7
1" high 3/4" High
Shim (2EA)
6" 6"
FIG. 37
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people are
needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit.
• When handling the air conditioner, be careful to avoid
cuts from sharp metal fins on front and rear coils.
• Make sure air conditioner does not fall during
removal.
• If unit does not operate after installation check, to be
sure the circuit interrupter has not been tripped. Refer
to the Troubleshooting guide for reset procedure.
CAUTION
Parts and Installation
PROCEDURE C CONTINUED
To achieve rearwardslope for unit draining,
remove the backing from the 1113/16"shim
strips anda ttachthem as shown below inFig.
37. The higher portion of shim is to be placed
in front of therib on the base of wall sleeve.
Install the new unit into the wall sleeve
8
9
Assemble trim as described in Step 6,
Procedure A.
FIG. 36