Hotpoint SE48101PGX manual Care and maintenance

Care and maintenance

Switching the appliance off

Disconnect your appliance from the electricity

Sliding rack kit assembly

To assemble the sliding racks: GB

supply before carrying out any work on it.

Cleaning the appliance

• The stainless-steel or enamel-coated external

parts and the rubber seals may be cleaned using

a sponge that has been soaked in lukewarm water

and neutral soap. Use specialised products for

the removal of stubborn stains. After cleaning,

rinse and dry thoroughly. Do not use abrasive

A

1.Remove the two frames, lifting them away from the spacers A (see figure).

	powders or corrosive substances.
•	The inside of the oven should ideally be cleaned
	after each use, while it is still lukewarm. Use hot
	water and detergent, then rinse well and dry with
	a soft cloth. Do not use abrasive products.
•	All accessories - with the exception of the sliding
	racks - can be washed like everyday crockery,
	and are even dishwasher safe.
•	We recommend that detergents are not sprayed
	directly onto the control panel, but that a sponge

is used instead.

Left	Right guide
guide rail	rail
B
	C Di
	of rect
	e	i
	x	on
	tract
		i
		on

2.Choose which shelf to use with the sliding rack. Paying attention to the direction in which the sliding rack is to be extracted, position joint B and then joint C on the frame.

￿Never use steam cleaners or pressure cleaners on the appliance.

Inspecting the seals

Check the door seals around the oven regularly. If the seals are damaged, please contact your nearest After-sales Service Centre (see Assistance). We recommend that the oven is not used until the seals have been replaced.

D

3.Secure the two frames with the guide rails using the holes provided on the oven walls (see diagram). The holes for the left frame are situated at the top, while the holes for the right frame are at the bottom.

Replacing the light bulb

To replace the oven light bulb:

Oven compartment

Lamp

Seal

Glass door

1.Remove the glass cover using a screwdriver.

2.Remove the light bulb and replace it with a similar one: Wattage 15 W, cap E 14.

Replace the glass cover, making sure the seal is positioned correctly (see diagram).

4. Finally, fit the frames on the spacers A.

￿Do not place the sliding racks in position 5.

Automatic cleaning with the FAST CLEAN function

With the FAST CLEAN mode, the internal temperature of the oven reaches 500°C. The pyrolytic cycle is activated and burns away food and grime residues. Dirt is literally incinerated. Keep children away from the appliance during the automatic cleaning cycle as surfaces may become very hot. Particles may ignite inside the oven due to the spontaneous combustion process. There is no cause for concern: this process is both normal and hazard-free.

13