Hotpoint SE61X operating instructions Electronic cooking programmer, Display will read as follows

The electronic cooking programmer

This feature allows you to program the oven or the grill as follows:

•delayed cooking time for a specified period;

•immediate start for a specified period;

•timer.

Button Functions:

H : Timer with hours and minutes;

$: cooking time;

%: end cooking time; ( : Manual change;

) : set cooking time (to count down);

* : set cooking time (to start from zero)

How to reset the digital clock

After the appliance has been connected to the power supply, or after a power cut, the clock display will automatically reset to 0:00 and begin to blink.

•Press the $ and % buttons consecutively and then reset the time (within 4 seconds) using the ) and * buttons.

The button * advances the hours. The button ) decreases the hours.

The time can also be changed in the following two ways:

1.Repeat all of the steps above.

2.Press the ( button, and then use the ) and * buttons to reset the time.

Manual operation of the oven

Once the time has been set, the programmer automatically switches to manual mode.

!Press the ( button to restore the manual mode after every “Automatic” cooking session.

Delayed cooking time for a specified period

The total cooking time as well as the time at which the cooking will finish must be set. If we assume that the time display reads10:00:

1. Turn the oven control knob to the setting and tempe- rature desired (example: static oven mode at 200°C).

2. Press the button $ and then set the cooking time (within four seconds) using the ) and * buttons. Supposing the cooking time is set to 30 minutes, the

display will read as follows:

+

Release the button, and within 4 seconds, the current time will reappear with the m symbol along with the word “auto” 3. Press the button % and then use the ) and * buttons to set the time for when the cooking program should

end. Let us imagine this time to be 1:00 p.m.

=

4. After the button has been released, the current time

will be displayed after approximately 4 seconds:

?

When “auto” is on, it indicates that the length of

cooking time and the time it is due to finish have been GB programmed in automatic mode. At this point, the

oven will turn on automatically at 12:30 and turn off after 30 minutes. When the oven is turned on, the symbol m will be displayed for the entire cooking time. The cooking duration can be displayed at any time by pressing the button $ , and the time it is due to finish may be displayed by pressing the button % .

Once cooking is completed, the timer will ring; to turn it off, simply press any button except the ) and *

buttons.

Immediate start for a specified period

By programming just the duration (points 1 and 2 of the “Delayed cooking time for specified period” section), cooking will begin immediately.

To cancel a cooking schedule already programmed Press the $ button, and use the ) button to set the time to:

,

then press the manual cooking mode button (.

Timer Feature

The timer feature allows you to enter a specific amount of time and begins to count down. This feature does not turn the oven on or off; it merely sounds when the time has elapsed.

When the button “ has been pressed, the display will read as follows:

,

Then use the * and ) buttons to set the desired time. As soon as the button has been released, the timer will start to count down and the current time will be displayed.

.

After the time has expired, an audible signal will be emitted, which can be turned off by pressing any button (except the * and ) buttons). At this point the symbol H will also turn off.

Correction/Cancellation of data

•The data entered can be changed at any time by pressing the corresponding button and the * or ) buttons.

•When the data for the cooking duration is cancelled, the data for the time cooking is due to end is also cancelled automatically, and vice versa.

•If the oven has already been programmed, it will not accept times for the end of cooking which are before the start of the programmed cooking process.

7