Hotpoint SE861X manual Maintenance and care

Maintenance and care

Switching the appliance off

Disconnect your appliance from the electricity supply before carrying out any work on it.

Cleaning the appliance

•The stainless-steel or enamel-coated external parts as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and neutral soap. If these stains are difficult to remove, use only specialised products. After cleaning, rinse and dry thoroughly. Do not use abrasive powders or corrosive substances.

•Ideally, the inside of the oven should be cleaned after each use, when it is still lukewarm. Use hot water and detergent, rinse and dry with a soft cloth. Do not use abrasive products.

•The accessories can be washed like everyday crockery (even in your dishwasher).

Cleaning the oven door

Clean the glass door using non-abrasive products and sponges and dry it with a soft cloth.

To clean more thoroughly, you can remove the oven door.

1.Open the oven door fully (see diagram).

2.Lift up and turn the small levers located on the two hinges (see diagram).

Replacing the light bulb

GB

To replace the oven light bulb:

1. Remove the glass cover of the lamp-holder.

2. Remove the

light bulb and replace it with a similar one:

Wattage 25 W,

cap E 14.

3. Replace the glass cover (see diagram).

Sliding Rack Kit Assembly

To assemble the sliding racks:

1.Remove the two frames, lifting them away from the spacers “A” (see figure).

F

3. Grip the door on the two

external sides and close it

approximately half way. Unlock

the door by pressing on the

clamps F, then pull the door

towards you lifting it out of its

Left	Right guide
guide rail	rail
B
	C	D
	o ire
		f	c
		e	ti
		x		on
		tra
			c
				ti
				on

2.Choose which shelf to use with the sliding rack. Paying attention to the direction in which the sliding rack is to be extracted, position joint B and then joint C on the frame.

seat (see diagram).

To replace the door, reverse

this sequence.

3. Secure the two

frames with the guide

rails using the holes

provided on the oven

walls (see diagram). The

Inspecting the seals

Check the door seals around the oven periodically. If the seals are damaged, please contact your nearest After-sales Service Centre (see Assistance). We recommend not using the oven until the seals have been replaced.

holes for the left frame

are situated at the top,

while the holes for the

right frame are at the

bottom.

4. Finally, fit the frames on spacer A.

13