Hotpoint SH103PX S manual Cleaning the oven door, Replacing the light bulb, Inspecting the seals

GB	Cleaning the oven door
	Clean the glass part of the oven door using a sponge and a non-abrasive

Replacing the light bulb

cleaning product, then dry thoroughly with a soft cloth. Do not use rough

abrasive material or sharp metal scrapers as these could scratch the surface

and cause the glass to crack.

To clean the oven more thoroughly, you can remove its door:

1. Open the oven door fully (see diagram);

Oven

compartment

Lamp

Seal (only on a

few models)

Glass door

To replace the oven light bulb:

1.Remove the glass cover of the lamp-holder.

2.Remove the light bulb and replace it with a similar one: Wattage

25W, cap E 14.

3.Replace the glass cover (see diagram).

2. Lift up and turn the small levers located on

the two hinges (see diagram);

!Do not use the oven lamp as/for ambient lighting.

Automatic cleaning with the FAST CLEAN function

With the FAST CLEAN mode, the internal temperature of the oven reaches 500°C. The pyrolytic cycle is activated, burning away food and grime residues. Dirt is literally incinerated.

Keep children away from the appliance during the automatic cleaning cycle as surfaces may become very hot. Particles may ignite inside the oven as a result of the combustion process. There is no cause for concern: this process is both normal and hazard-free.

3. Grip the door on the two external sides and close it approximately half way. Pull the door towards you, lifting it out of its slot (see diagram).

To replace the door, reverse this sequence.

Inspecting the seals

Check the door seals around the oven regularly. If the seals are damaged, please contact your nearest Service Centre (seeAssistance). We recommend that the oven is not used until the seals have been replaced.

Before initiating the FAST CLEAN mode:

•clean the oven door;

•remove large or coarse food residues from the inside of the oven using a damp sponge. Do not use detergents;

•remove all accessories and the sliding rack kit (where present);

•do not place tea towels or pot holders over the oven handle.

!If the oven is too hot, the pyrolytic cycle may not start. Wait for the oven to cool down.

!The programme may only be started once the oven door has been closed.

To activate the Fast Clean programme:

1. Switch the control panel on by pressing the button.

2. Press the button; the TIME display will show the default duration of 1:30 h (normal cycle), while he TEMPERATURE display will show “Piro” and “nor” alternately;

3.The desired cleaning level can be selected by pressing the button, then: - pressing to switch to the intensive cycle: the duration is 2 h and the TEMPERATURE display shows the text “Piro” and “int” alternately;

- pressing to switch to the economy cycle: the duration is 1 h and the TEMPERATURE display shows the text “Piro” and “eco” alternately.

Safety devices

•the door locks automatically as soon as the temperature reaches a high

value; the icon lights up on the display;

•pressing the button cancels the cleaning cycle t any time;

•if a malfunction occurs, the heating elements will be switched off;

•once the oven door has been locked, you cannot change the duration and end time settings.

*Only available on certain models.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

12