Hotpoint SX manual Electrical connection, Electrical Connection

Electrical connection

GB

The electrical connection to the mains must be made on the appliance. The power voltage and frequency are as indicated on the rating plate.

!THIS APPLIANCE MUST BE EARTHED.

Connecting the power supply cable

To open the terminal board:

•Using a screwdriver, press on the tabs situated on each side of the terminal board cover.

•Pull open the terminal board cover.

To connect the power supply cable, proceed as follows:

•Unscrew the cable clamp screw and the contact screws L-N-.

•Fasten the wires beneath the screwheads using the following colour scheme: Blue (N) Brown (L) Yellow-Green

•Fasten the power supply cable in the corresponding cable clamp and close the cover.

Electrical Connection:

Voltage Frequency: 230

V-1+N 50Hz

Fuse Section: 16A

Supply cable: 3x1.5mm2

4 2

NL

You can connect your oven to the system means of a terminal board. Refer to above information for the minimal cable sections and the calibration of the protective elements according to the connection.

If the appliance is installed with a junction box, an omnipolar circuit breaker - with a minimum contact opening of 3mm - should be installed between the appliance and the mains.

Power cable supply connection to the electrical mains:

We recommend you use a power supply cable which is long enough to allow you to take the oven out of its recess in the event of maintenance operations (only use HAR - H 05 - RRF quality cables fitted with a plug conforming to the regulations in force.

The plug must be accessible at all times.

Unplug the appliance before all operations, even when replacing the oven lamp.

Using the appliance without correct earthing is highly dangerous.

!After connecting the appliance to the flexible cable, tighten all the screws on the terminal board.

APPLIANCE SPECIFICATIONS

Dimensions	width 43.5 cm
	height 32 cm
	depth 41.5 cm
Volume	58 l
Electrical	Voltage at 220-240 V~ 50/60 Hz or
	50 Hz (see data plate)
connections	maximum power absorbed 2800 W
	Directive 2002/40/EEC on the
	label of electric ovens.
	Standard EN 50304
ENERGY	Energy consumption for Natural
	convection – heating mode:
LABEL	Traditional mode
	Declared energy consumption
	Forced convection class -
	heating mode:
	Baking.
	This appliance conforms to the
	following EEC Directives:
	2006/95/EEC dated 12/12/06
	(Low Voltage) and subsequent
	amendments - 2004/108/EEC
	dated 15/12/04 (Electromagnetic
	Compatibility) and subsequent
	amendments - 93/68/EEC dated
	22/07/93 and subsequent
	amendments. 2002/96/EEC
	and subsequent amendments.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

4