Hotpoint SX 896L PX manual Automatic cleaning with the FAST CLEAN function, walls see diagram

Left	Right guide
guide rail	rail
B
	C
	of
		Direction
		extraction

2. Choose which shelf

to use with the sliding

rack. Paying attention

to the direction in which

the sliding rack is to be

extracted, position joint

B and then joint C on

the frame.

To activate the Fast Clean programme:

1. Switch the control panel on by pressing the button.

2. Press button ; the display will show the text “Piro”, “nor” and the default duration of 1:30 h (normal cycle) alternately.

3. Press button , then turn the TIMER knob to adjust the default cleaning level. There are 3

GB

D

3. Secure the two

frames with the guide

rails using the holes

provided on the oven

walls (see diagram).

The holes for the left

frame are situated at

the top, while the holes

for the right frame are

at the bottom.

different levels to choose from, each with a pre-set duration which cannot be modified:

1.Economy (ECO): turn the knob towards “-”. Duration 1 hour.

2.Normal (NOR): initial level. Duration 1 hour and 30 minutes.

3.Intensive (INT): turn the knob towards “+”. Duration 2 hours.

4.Press the button to confirm.

5.Press the button to begin the cleaning cycle.

4. Finally, fit the frames on the spacers A.

!Do not place the sliding racks in position 5.

Automatic cleaning with the FAST CLEAN function

With the FAST CLEAN mode, the internal temperature of the oven reaches 500°C. The pyrolytic cycle is activated, burning away food and grime residues. Dirt is literally incinerated.

Keep children away from the appliance during the automatic cleaning cycle as surfaces may become very hot. Particles may ignite inside the oven as a result of the combustion process. There is no cause for concern: this process is both normal and hazard-free.

Before initiating the FAST CLEAN mode:

•clean the oven door;

•remove large or coarse food residues from the inside of the oven using a damp sponge. Do not use detergents;

•remove all accessories and the sliding rack kit (where present);

•do not place tea towels or pot holders over the oven handle.

!If the oven is too hot, the pyrolytic cycle may not start. Wait for the oven to cool down.

!The programme may only be started once the oven door has been closed.

An end time for the FAST CLEAN cycle (as for a normal cooking cycle) may be programmed (see Programming the automatic cleaning end time).

Safety devices

•the door locks automatically as soon as the

temperature reaches a high value; the icon lights up on the display;

•pressing the button cancels the cleaning cycle at any time;

•if a malfunction occurs, the heating elements will be switched off;

•once the oven door has been locked, you cannot change the duration and end time settings.

Programming the automatic cleaning end time

1.Press the button twice: the icon and the numerical digits on the display will begin to flash.

2.Turn the TIMER knob towards “+” and “-” to adjust the cleaning end time value.

3.Once you have reached the desired end time,

press the button again. The display will show the duration, the cleaning end time and the set cleaning level alternately.

4.Press the button to activate the programmed mode.

Programming has been set when the and buttons are illuminated.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

13