Hotpoint SX 896L PX S Replacing the light bulb, Cleaning the oven door, Sliding rack kit assembly

Use specialised products for the removal of stubborn GB stains. After cleaning, rinse and dry thoroughly. Do not

Replacing the light bulb

use abrasive powders or corrosive substances.

•The inside of the oven should ideally be cleaned after each use, while it is still lukewarm. Use hot water and detergent, then rinse well and dry with a soft cloth. Do not use abrasive products.

•All accessories - with the exception of the sliding racks

- can be washed like everyday crockery, and are even dishwasher safe.

•We recommend that detergents are not sprayed directly onto the control panel, but that a sponge is used instead.

Lamp

Holder

compartment

Lamp

Glass cover

To replace the oven light bulb:

1.Remove the glass cover of the lamp-holder.

2.Remove the light bulb and replace it with a similar one: halogen lamp voltage 230 V, wattage 25 W, cap G 9.

3.Replace the glass cover (see diagram).

!Never use steam cleaners or pressure cleaners on the appliance.

Cleaning the oven door

! The door of LED INSIDE models cannot be removed.

Clean the glass part of the oven door using a sponge and

!Do not touch the light bulb directly with your hands.

!Do not use the oven lamp as/for ambient lighting.

Sliding rack kit assembly

a non-abrasive cleaning product, then dry thoroughly with

a soft cloth. Do not use rough abrasive material or sharp

metal scrapers as these could scratch the surface and cause

the glass to crack.

For more thorough cleaning purposes, the oven door may

be removed:

1. Open the oven door fully (see diagram).

2. Use a screwdriver to lift up and turn the small levers F

located on the two hinges (see diagram).

F

3. Grip the door on the two outer sides and close it approximately half way. Pull the door towards you,

		A
Left	Right guide
guide rail	rail
B
	C
	of
		Direction
		extraction

To assemble the sliding racks:

1.Remove the two frames, lifting them away from the spacers A (see figure).

2.Choose which shelf to use with the sliding rack. Paying attention to the direction in which the sliding rack is to be extracted, position joint B and then joint C on the frame.

lifting it out of its slot (see diagram). To replace the door, reverse this sequence.

Inspecting the seals

Check the door seals around the oven regularly. If the seals are damaged, please contact your nearest Service Centre (see Assistance). We recommend that the oven is not used until the seals have been replaced.

D

3.Secure the two frames with the guide rails using the holes provided on the oven walls (see diagram). The holes for the left frame are situated at the top, while the holes for the right frame are at the bottom.

4.Finally, fit the frames on the spacers A.

!Do not place the sliding racks in position 5.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

12