![](/images/new-backgrounds/1320425/32042527x1.webp)
The Controls - TDL10 and TDL11
Heat Switch (OUT low heat, IN high heat) | Timer Knob | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Drying Guide | Drying Times |
TDL10 | Turn the timer clockwise to select the required drying time. The drying time for | |
| both heat settings is controlled by the timer. All you have to do is turn the Timer | |
| Knob clockwise until it lines up with the required time. | |
| Do not rotate the knob beyond 120 (maximum drying time), or past the zero | |
| stop. If you have selected more time than you required, turn the knob anti- | |
| clockwise, to select the correct time required. | |
| This operation also starts the dryer, provided the door is closed and the | |
| machine is plugged in. The “Guide To Drying Times” section will tell you how | |
| much time you’ll need for various loads. |
|
|
| |
TDL11 | Turn the timer clockwise to select the required drying time. The drying time for | |
| both heat settings is controlled by the timer. All you have to do is turn the Timer | |
| Knob clockwise until it lines up with the required time. | |
| Never wind the timer control | |
| This operation also starts the dryer, provided the door is closed and the | |
| machine is plugged in. The “Guide To Drying Times” section will tell you how | |
| much time you’ll need for various loads. |
|
|
| |
Heat Selection | The button is ‘OUT’ for LOW heat and ‘IN’ for HIGH heat. | |
TDL10 and TDL11 | The choice of FULL HEAT or LOW HEAT depends upon the fabric you wish to | |
| dry (see section, ‘Sorting your Laundry’) |
|
|
|
|
The ‘Cool Tumble’ phase TDL10 and TDL11
About 10 minutes before the programme is completed, the heating elements will be switched off, and the programme enters the final ‘Cool Tumble’ phase. During this phase, the fabric is cooled. You should always allow the dryer to complete this phase.
By opening the door, the dryer will stop and you can check the dryness of the load as often as you wish and, if you want to remove (or add) some items before they are fully dry. (This is particularly useful for a mixed load where you want to iron some items,but others to be fully dried).
We recommend that the clothes are removed immediately the programme is finished to minimise creasing.
NEVER SWITCH THE DRYER ‘OFF’ WITH A HOT LOAD IN THE DRUM. YOU MUST TERMINATE EVERY PROGRAMME WITH THE COOL TUMBLE PHASE.
14