Troubleshooting
In the unlikely event that you have problems with your machine, the following guide will enable you to resolve many problems without having to call out a service engineer.
Fault Area | Issue | Cause/How to resolve… |
The Dishwasher Will Not Start
Salt Symbol Flashing/Not
Going Out When Salt
Added
Rinse Aid Light Flashing/
Not Going Out When Rinse
Aid Added
Leaking From Rear Of Machine
Possible Installation/Electrical SupplyFault
(Particularly if the machine is being used for the first time)
Salt symbol will flash if:
-Youareusingthemachinefor thefirsttime
Or
-The salt level is low.
Rinse Aid symbol will flash if:
Or
The rinse aid level is low.
Possible Incorrect Fitment of Water Inlet Hose.
●Check
-Isthedishwasherpluggedinandswitchedon?
-Isthereapowerfailure,checktoseeifotherappliancesworking.
-Checkthefuse.
-Isthereafaultwiththewatersupply/isthewatersupplytapturnedon?
-Isthewaterpressuresupplysufficient?
-Is the inlet hose kinked?
-Isthedoorclosedproperly?
-The Salt symbol will flash when your dishwasher is switched on for
PleaseNote:
-The salt symbol will remain lit in the display after the salt has been addedforseveralconsecutivecycles.
-If you are using 3 in 1 tablets and do not add salt then the salt symbol will flash periodically for several consecutive cycles.
TheRinseAidsymbolwillflashwhenyourdishwasherisswitchedon forthefirsttimeandagainwhentherinseaidlevelsbecomelow– followtheinstructionson“BeforeUsingYourDishwasher”pageon howtoaddrinseaid.
PleaseNote:
-The rinse aid symbol will remain flashing in the display after the rinse aidhasbeenadded,andwillcontinuetoflashuntilthemachinehas completedthenextfullwashcycle(Note:TheFast&Prewashcycles are not full wash cycles).
·Check
Isthewaterinlethoseconnectionsecuredatrearofmachine(Fig.1).
Machine Connection
F i g . 1
15