Start and Programmes

Choosing a programme

1.Plug the dryer into the electrical socket.

2.Sort your laundry according to fabric type (see Laundry).

3.Open the door and make sure the filter is clean and in place (see Maintenance).

4.Load the machine and make sure items are not in the way of the door seal. Close the door.

5.Choose a drying time or programme, the way you do this depends on the type of dryer you have:

Model VTD00

-choose a drying time by checking the Drying Guide table for the type of fabric you are drying (see Laundry).

-set the temperature with the HEAT button.

-select a drying time by rotating the TIMER knob clockwise, never counter-clockwise, until the indicator is pointing to the drying time you want.

Model VTD20

-choose a drying programme by checking the Programmes table (see Programmes) as well as the indications for each type of fabric (see Laundry).

-set the temperature with the HEAT button.

-select a programme or drying

time by rotating the PROGRAMME knob clockwise, never counter-clockwise, until the indicator is pointing to the drying time or programme you want.

6.(VTD20 only):

-Set a delay time by using the DELAY knob if necessary.

: rotate it clockwise until you reach the number of hours you want to delay the start time.

If you have gone too far, turn the knob counter-clockwise.

7.(VTD20 only) If you wish to eliminate the buzzer sound at the end of the programme, press the ALARM button.

8.Press the START button to begin.

The ACTIVE indicator light (VTD20 only) will turn on and will stay on, even during the delay.

The indicator light will remain on until you open the door.

During the drying programme, you can check on your laundry and take out the items that are dry, while the others continue drying. When you close the door again, press START in order to resume drying.

9.About 10 minutes before drying is completed, it enters the final COOL TUMBLE phase (fabrics are cooled), which should always be allowed to be completed.

10.(VTD20 only) The buzzer, if ALARM was selected, will warn you when drying is complete.

11.Open the door, take the laundry out, clean the filter and replace it (see Maintenance).

12.Unplug the dryer.

GB

Information

Important

 

 

Installation

 

 

 

Description

 

 

 

Programmes

Startand

 

 

Laundry

 

 

 

Suggestions

Warningsand

 

 

andCare

Maintenance

 

 

Troubleshooting

 

 

 

Service

 

 

 

5

Page 7
Image 7
Hotpoint manual Start and Programmes, Choosing a programme, Model VTD00, Model VTD20