Hotpoint VTD00 manual Programmes table VTD20 only, Easy Iron Programme, Fabric

Start and Programmes

GB	Programmes table (VTD20 only)
	Programme	What it does...	How to set it...			Note:
	Automatic	Dries completely:	1.	Select HIGH HEAT by pressing		! If you select LOW HEAT, this
	Drying	your clothes are ready to be		the HEAT button.		programme will not dry your
	(average loads)	worn. For average loads (from	2. Position the PROGRAMMES knob			clothes. For Acrylic fibres or
						small loads select Timed
				on	.
		1 to 3kg) of Cotton, polycotton				Drying.
			3. Press the START button, the
		or synthetics.
				ACTIVE light will turn on.		This programme can also be
						used for large loads if you
						require a slightly drier result.
	Automatic	Dries completely:	1.	Select HIGH HEAT by pressing		! If you select LOW HEAT, this
	Drying	your clothes are ready to be		the HEAT button.		programme will not dry your
	(large loads)	worn. For large loads (from 3	2.	Position the PROGRAMMES knob		clothes. For Acrylic fibres or
						small loads select Timed
				on	.
		to 6kg) of Cotton.				Drying.
			3.	Press the START button, the
				ACTIVE light will turn on.		This programme can also be
						used for average loads if you
						prefer a damper result.
	Easy Iron	Brief programme	1.	Select HIGH HEAT by pressing		! This is not a drying
		(approximately 10 minutes)		the HEAT button.		programme (see below).
		that softens fibres of clothing	2.	Position the PROGRAMMES knob
		that is ready for ironing.		on	.
			3.	Press the START button , the
				ACTIVE light will turn on.
	Timed Drying	Dries wet clothes that will be	1.	Select required heat setting HIGH		Consult suggested drying
	up to 120 minutes	ironed, Acrylic fibres, or small		HEAT or LOW HEAT by pressing		times (see Laundry).
		loads (less than 1kg).		the HEAT button.
			2.	Position the PROGRAMMES knob
				on the desired time.
			3.	Press the START button, the
				ACTIVE light will turn on.
	Cool Tumble	Heating elements turn	This is the programmes final phase.			Always allow the dryer to
	Phase	themselves off and clothing	Approximately 10 minutes before			complete this phase.
			the finish, the knob advances
		is cooled down.
			automatically to the Cool Tumble
			Phase. After this, the Buzzer will
			sound (if selected) and the clothing
			is ready to be taken out.

Easy Iron Programme

‘Easy Iron’ is a short 10 minute programme (8 minutes of heat followed by a 2 minute cool tumble period) which fluffs the fibres of clothing that have been left in the same position/location for an extended period of time. The cycle relaxes the fibres and makes them easier to iron and fold.

!‘Easy Iron’ is not a drying programme and should not be used for wet articles of clothing.

For best results:

1.Do not load more than the maximum capacity. These numbers refer to the dry weight:

Fabric	Maximum load
Cotton and Cotton mixtures	2.5kg
Synthetics	2kg
Denim	2kg

2.Unload the dryer immediately after the end of the programme, hang, fold or iron the articles and put them away in the closet. Should this not be possible repeat the programme.

The ‘Easy Iron’ effect varies from one fabric to the next. It works well on traditional fabrics like Cotton or Cotton mix, and less well on acrylic fibres and on materials such as Tencel®.

6