Hotpoint WD52 manual Installation, Youimportant, Front Feet are S Firm and LEVEL. k and The Foot

Models: WD52

1 12
Download 12 pages 37.62 Kb
Page 3
Image 3

Installation

2

REMOVE TRANSIT BRACKETS...

3 CONNECT TO TH

YOUIMPORTANT:

Internal transit brackets are fitted to prevent damage during transit and MUST be removed before use...

Failure to do so may cause damage to your machine!

 

 

 

Remove and

 

From the rear of the

 

machine, grip sides of

retain 3 screws

 

 

the worktop lid, lift, slide

from the back of

 

 

and pull towards you.

the worktop lid

 

 

 

Slide and push worktop lid back into position, ensuring front edge is correctly located into the console.

 

 

 

 

 

Remove 4 screws

 

Remove 3 screws

and the rear transit

 

and front transit

bracket - retain.

 

bracket - retain.

 

 

 

 

 

 

 

 

 

 

Replace the work top lid using the 3 original screws.

PLEASE USE THE NEW HOSES SUPPLIED, FITTED TO THE MACHINE.

DO NOT REMOVE!

Old hoses may cause leaks due to worn out washers.

DRAINAGE SYSTEM... we recommend one of the following:

TE: ALTHOUGH YOU MAY NEED TO OVE THE HOOKED END SUPPORT ONG THE GREY DRAINAGE HOSE,

DO NOT REMOVE IT.

HICHEVER DRAINAGE METHOD OU USE, MAKE SURE THAT THE OOKED END SUPPORT IS FIXED VEL TO, OR ABOVE THE ‘MINIMUM DRAINAGE HOSE HEIGHT LINE’*

ee Getting to Know your Appliance)

STANDPIPE METHOD

Hooked End Support

Insert drainage hose approximately 100mm into the standpipe.

.............................

Standpipe height: minimum 500mm from the floor.

OR

UNDER SINK METHOD

cut off the blocked end of the under sink drainage unit.

800mm from floor

Fix the hooked

Attach the GREY

end support at

drainage hose to the

a minimum

under sink drainage

800mm from

unit securely, using a

the floor.

hose clip.

O FRONT FEET ARE S FIRM AND LEVEL. k and The Foot

ONLY the locking disk e two front feet until is up against the base e machine.

6

CONNECT TO THE POWER SUPPLY...

PLUG YOUR MACHINE INTO AN ELECTRICAL SOCKET WHICH IS EASILY ACCESSIBLE. SWITCH ON

NOTE: Hotpoint recommend extension leads are not used.

Move your machine into position, take care not to trap or kink the hoses.

7

READY...

TO CHECK ALL PARTS CLEAN THE INSIDE OF

SELECT A 95˚ WHITE

WITH

THIS WILL TAKE A

Page 3
Image 3
Hotpoint WD52 manual Installation, Youimportant, Front Feet are S Firm and LEVEL. k and The Foot