GB

The machine is noisy.

The machine wont spin properly.

The machine leaks from the dispenser.

The machine leaks (other than dispenser).

There will always be some motor, pump and drum noise during spin.

Out of Balance detected when attempting to go into a spin cycle - If this happens the machine will continue to try to repeat the distribution of the load required before the machine will go into higher spin speeds - This will increase the programme time accordingly. This is a safety feature to prevent damage. Out of Balance can be caused by washing a single heavy item (eg duvet, quilt, etc). - Try the programme again using a different load.

The dispenser drawer is blocked with detergent and requires cleaning.

The water pressure is too high and requires turning down - turn down the tap on the water supply pipe slightly and try again.

The machine is tilting forwards - It must be level when in its final position.

The fill hose is loose, check both the cabinet and tap ends.

The fill hose is tight but still leaks, if so replace the rubber washers, or the fill hose is missing the rubber washer.

The drain hose is not fixed in properly.

The indicator lights on the console are flashing rapidly.

The machine smells.

The machine door cannot be opened.

Door Seal damaged at the bottom.

The water level is too low when the machine is washing.

There is too much foam.

Switch off the machine and unplug it, wait for approximately 1 minute and then switch it back on again If the problem persists contact the Technical Assistance Service.

The machine requires a service wash. Run a 90 degree wash cycle with deter- gent and no laundry.

The door will not open until the door lock indicator light goes out shortly after the program has finished.

The door seal has drainage holes at the bottom - This is normal.

The water level is correct if it can be seen at the bottom of the door.

The detergent is not suitable for machine washing (it should display the text

‘for washer-dryers’ or ‘hand and machine wash’ or the like).

Too much detergent was used - less detergent is required in soft water.

After completing the programme, or before starting a programme, the machine has turned itself off (no lights).

General.

To comply with new energy saving regulations the machine is fitted with an automatic standby system. Press ‘ON/OFF’ button for 3 seconds to activate the machine, it can then either be switched off or a new programme selected.

Your washer-dryer contains sensors that monitor progress during the wash cycle (eg: Water Levels, Temperatures, Out of Balance loads, Wash time/pro- gress).

Normally, if your machine successfully completes the cycle, there is unlikely to be anything wrong!

Remember, you will be charged for a service call for problems caused by incorrect installation, as listed above. Not emptying contents from pockets may cause pump or drain blockages, or may damage the machine. Do not wash items which do not have a wash label, or wash items that are not intended as machine washable.

14

Page 14
Image 14
Hotpoint WDAL 8640, WASHER-DRYER manual