Hotpoint WDAL 8640, WASHER-DRYER manual First wash cycle, Bution board

	As the colours of the wires in the lead may not correspond
GB
	with the coloured markings identifying the terminals in your
	plug, proceed as follows:
	Connect Green & Yellow wire to terminal marked E or
	or coloured Green or Green & Yellow.
	Connect Brown wire to terminal marked L or coloured Red.
	Connect Blue wire to terminal marked N or coloured Black.
	If a 13 amp plug (BS 1363) is used it must be fitted with a
	13 amp fuse, either in the plug or adaptor or at the distri-
	bution board.
	If you are in any doubt regarding the electrical supply to
	your machine, consult a qualified electrician before use.
	How to connect an alternative plug:
	The wires in this mains lead are coloured in accordance
	with the following code:
	BLUE		NEUTRAL (N)
	BROWN		LIVE (L)
	GREEN & YELLOW		EARTH (E)
	GREEN &
	YELLOW
	BROWN	13 ampere fuse
	BLUE	CROSS-BAR
		CORD GRIP

Disposing of the appliance:

When disposing of the appliance please remove the plug by cutting the mains cable as close as possible to the plug body and dispose of it as described on the previous page.

!The washer-dryer should not be installed in an outdoor environment, not even where the area is sheltered, becau- se it may be very dangerous to leave it exposed to damp, rain and thunderstorms.

!When the washer-dryer is installed, the mains socket must be within easy reach.

!Do not use extensions or multiple sockets.

!The power supply cable must never be bent or dange- rously compressed.

!The power supply cable must only be replaced by an authorised serviceman.

Warning! The company denies all liability if and when these norms are not respected.

The first wash cycle

Once the appliance has been installed, and before you use it for the first time, run a wash cycle with detergent and no laundry, using the programme “Auto Clean” (see “Cleaning the washer-dryer”).

4