5.Grasp the Mylar tab on the drive, lift the drive up (4), and then slide it out of the drive bay.

Reverse this procedure to install the hard drive.

To remove the solid-state drive:

1.Release the ZIF connector (1) to which the USB board pass-through cable (that lies across the top of the drive) is attached.

2.Disconnect the USB board pass-through cable (2), and then detach the tape from the top of the drive.

3.Release the LIF connector (1) to which the solid-state drive cable is attached, and then disconnect the cable (2).

4.Remove the two black Phillips PM2.0×3.0 screws (3) that secure the drive bracket to the device.

36 Chapter 4 Removal and replacement procedures